Professional Sound Corporation DV PROMIX 3 Quick Start Manual
PROFESSIONAL SOUND CORP.
QUICK START GUIDE
1. BATTERIES
Install two, fresh 9V alkaline batteries noting the correct polarity.
2. POWER SWITCH
DV PROMIX 3
Set the power switch to the internal battery by moving it upward towards the “BATT”
marking.
3. INPUT LEVELS
Select the appropriate input level by selecting “D”, “L” or “C” on the toggle switch located
next to each input XLR connector. Select “D” for use with Dynamic microphones (nonpowered microphones). Select “L” for use with line level sources such as the line
outputs from CD players. Select “C” for use with condenser microphones (48PH
powered microphones).
4. MICROPHONE POWER
Select “48PH” microphone power or “DYN” by selecting the switch located next to each
input XLR connector. Only select “48PH” when using microphones designed to operate
from 48PH or 9-52PH or 9-52 simplex power. For all other uses, select “DYN”.
5. CONNECT MICROPHONES
Connect your microphones using standard XLR microphone cables.
6. LOW CUT FILTERS
For use indoors, or outdoors with no wind present, select “20”. For outdoors with light
wind conditions, select “80”. For outdoors with high wind conditions, select “150”.
Loading...