Profax AEC 200-1 User Manual

Owners

Owners

Owners

Manual

Manual

Manual

e

as

um C

in

m

Alu

August 2006

7187

.

.

A

A

.

.

S

S

.

.

U

U

N

N

I

I

E

E

D

D

A

A

M

M

®

For use in connecting the AEC 200 Welding Gun

to a constant voltage welding power source.

Model AEC 200-1Model AEC 200-1

Model AEC 200-1

P.O. BOX 898 • PEARLAND, TX 77588-0898 • PHONE: [phone] • FAX: [phone]

Made in U.S.A.

WarrantyWarranty

Warranty

LIMITED WARRANTY - Subject to the terms and conditions hereof, PROFAX, Pearland, Texas warrants its control boxes to be

free from defect in workmanship and material at the time of delivery by PROFAX.

PROFAX will honor warranty claims on this equipment as a result of failure from a defect for a period of one year from date of

sale to the original user.

Upon the return of this unit at users expense, PROFAX reserves the right to either repair or replace as necessary.

This is the only warranty either expressed or implied covering this unit.

CAUTION

Disconnect all electrical power to

the welding power source before

installing this control unit.

To install:

1. Remove top cover from control unit.

2. Install the multi-conductor cord from the AEC 200 Welding Gun through the access hole in
the front panel of the control box and connect the numbered wires to the corresponding
numbers on the 8 pole terminal strip TS1.

3. Connect the contactor control cord on the back of the control box to the contactor control
receptacle on the welding power source.(See Note)

4. Connect the 115 volt A.C. power cord from the control box to a 115 volt A.C. power source.

5. Replace top cover and tighten screws.

NOTE

Terminals 1 and 2 on the four pole terminal strip TS2 are for use with welding power sources requiring a normally open
set of contacts for power source contactor operation. This set of contacts will close when the gun switch is operated.

Terminals 3 and 4 on the four pole terminal strip are for use with welding power sources requiring 115 VAC to be supplied
to the power source for contactor operation.

This control box comes with the contactor control cord connected to terminals 1 and 2.