DSP B210 Solo/Duo UHF Voice and Instrument Systems
User Manuel:
M850 DSP Solo / M850 DSP Duo / B210 DSP Solo / B210 DSP Duo / B210 DSP Headset / B210 Lavalier tie-clip
microphone
Safety Information
This logo indicates that the product can be recycled after it has been used. Please do not dispose of the product
with your normal household waste. Return the product to the shop where you purchased it or place it in the
designated recycling container.
Thank you for purchasing this digital appliance. To ensure perfect operation and security, please read
the manual carefully and retain it for future reference. This manual can be downloaded from our site.
CAUTION
Risk of electric shock
Do not open!
Precautions
The lightning flash with the arrowhead symbol in an equilateral triangle is intended to alert the user to the presence of noninsulated “dangerous voltage” inside the appliance that may be of sufficient magnitude to constitute a risk of electric shock.
The exclamation mark within an equilateral triangle is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the product.
Important Instructions
1) Read these instructions.
2) Retain these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this appliance near water.
6) Clean only with a dry cloth.
7) Do not block any of the ventilation openings that were installed in accordance with the manufacturer’s
instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other appliances (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide
blade or the third prong is provided for your safety. If the plug provided does not fit into your outlet,
consult an electrician to ensure replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and
the point where it exits from the appliance.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
appliance. If using a cart, be careful when moving the cart/appliance combination to avoid injury from tip over (Figure 1).
13) Unplug this appliance during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the appliance has been damaged
in any way, for example, the power-supply cord or plug is damaged, liquid has been spilled or objects have
fallen inside the appliance, the appliance has been exposed to rain or moisture, does not operate normally,
or has been dropped.
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
CAUTION: The appliance should not be exposed to drips or splashes of water. Objects filled with liquids, such as vases, should
12 – Table of frequencies ...................................................................... 11
1 – Introduction
This wireless microphone and bodypack system uses highly stable Phase-Locked Loop (PLL)
technology to eliminate unexpected disconnections. The power consumption of the microphone
transmitter and receiver have been calculated very precisely to ensure good battery life. Every
product is subject to strict controls by our quality department before it is offered for sale.
Safety Precautions
To ensure both your safety and the trouble-free operation of this product, please read
carefully the safety precautions on page 2 of this manual.
Important: to reduce the risks of electric shock, do not remove the rear panel of this
product. For any maintenance issues, please contact your dealer or a qualified technician.
2 – Declarations of conformity
These appliances conform with the essential requirements of European directive RED 2014/53/EU*.
Before using this appliance, please observe the legal stipulations applicable in your country. This radio
equipment is intended for use at professional spectacles, other similar applications and as auxiliary
radio broadcasting equipment.
*See declarations of conformity at www.prodipe.com
3 – DSP (Digital Signal Processor) Module
The DSP (Digital Signal Processor) technology of our UHF equipment provides very high levels of
stability in UHF signals. The extremely precise digital processing of UHF frequencies offers stable
performance in all circumstances and environments.
The electronic system of this DSP module is designed to resist any interference which may occur while
it is in use, guaranteeing the integrity of the signal at all times.
Voice and instrument sound using Prodipe DSP UHF will be as close as possible to wire transmission
quality.
Actual product(s) may differ from illustrations/photographs used
2- M850 Microphone (M850 DSP Solo et M850 DSP Duo):
1. Microphone unit and wire mesh cover.
2. LCD display.
3. ON | MUTE | OFF Switch: ON | MUTE | OFF.
4. Power supply and synchronisation tell-tale light.
5. Battery compartment LR6 / AA (x2).
6. Receiver [IR] for automatic channel selection.
6 – Configuration of transmission channels
Transmission channels are configured automatically. Hold the hand microphone (IR cell at the base of
the microphone with battery cover removed) or the body-pack (IR cell on front) facing the receiver
(IR cell in the middle of the front panel). Switch the bodypack to "ON" and press the "DOWN" [∇]
button on the hand microphone for a few seconds and hold against the transmitter to align the IR
cells (see diagram below).
Note:
M850 Microphone: IR cell at the base of the microphone under the battery cover.
B210 Bodypack: IR cell on front of bodypack.
Actual product(s) may differ from illustrations/photographs used
Press the "DOWN" [∇] button for a few seconds to start the automatic frequency search; once the
frequency has been selected, press the SET button briefly to synchronise the transmitter with the
receiver.
When the receiver light shows green, automatic synchronisation is complete.
To select a frequency manually, press the "UP" [∆] button and hold for a few seconds. When the
frequency flashes on the display, press "UP" [∆] or "DOWN" [∇], repeatedly until the desired frequency
is shown. Then synchronise the transmitter with the receiver by pressing the [SET] button briefly.
When the receiver light shows green, synchronisation is complete.
For DSP DUO UHF models with two M850 microphones or two B210 bodypacks you should carry out
the same procedure for each microphone or bodypack to synchronise them.
CAUTION, once you have synchronisd one microphone or bodypack you MUST switch it off
before synchronising the other.
Actual product(s) may differ from illustrations/photographs used
For better sound capture and a perceptible
volume increase with your M850 microphone,
point the head towards the sound source and
keep it away from undesired sounds.
Do not cover any part of the wire mesh with
your hands. Covering the mesh alters the
sound and distorts the polarity, increasing the
risk of feedback.
To avoid this problem, first lower the
microphone volume, then hold it a little further
away from the speaker or singer's mouth.
Headset
micropho
ne
The headset microphone, which can be used
with the B210 Bodypack, should be positioned
as close as possible to the mouth but off the
direct axis, to suppress plosive sounds in
speech.
If you are using a Prodipe Lavalier tie-clip microphone, refer to the accompanying user
manual for the best position.
If you are using microphones from the Prodipe 21 Series, refer to the accompanying user
manuals for the best position.
8 – General characteristics of DSP UHF
UHF receiver with 100, 2x100 or 2x50 Phase-Locked Loop (PLL) channels see technical
characteristics in this manual for further information.
DSP digital processing module.
Infra-red [IR] carrier frequency synchronisation.
Very high fidelity audio module.
"Super anti-jamming" circuits.
Extremely low background noise.
Interference-free automatic selection of available frequencies.
Manual frequency selection.
M85 microphone unit fitted in M850 hand microphone.
Simultaneous use: up to 8 DSP UHF transmitter/receiver systems
Actual product(s) may differ from illustrations/photographs used
Particles and dust may stick to the mesh and filter, altering the microphone's
frequency response. The mesh (without the filter) should be disassembled regularly
and cleaned with warm, soapy water, rinsed with clean water, dried and
reassembled.
The microphone unit is very sensitive. Please do not drop the microphone and avoid
any shocks which might damage the unit.
To preserve the sensitivity and sound reproduction quality of your microphone, it
should never be exposed to humidity or extreme temperatures (e.g. direct sunlight).
Prodipe and its distributors disclaim all liability for damage to this device resulting
from use other than as described above.
Actual product(s) may differ from illustrations/photographs used