Model 7035
Clamp-On Half Rails
OPERATOR’S MA
NUAL
NOTE: Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact medical equipment provider for further instruction.
Inde
x
1. Warnings……………………………………..………………..………....2
2. Installation……………..…………………………………………..……..3
3. Raising and Lowering Rails……………….…………………….. …….3
4. Limited Lifetime Warranty……………………………………… …...3-4
WARNINGS
WARNING:
insta
lli
ng
understand
healthcare dealer for
Half Rails are
damage to the Clamp-On Half Rail could result.
For
information
Guide to Bed Safety: Bed Rails in
Health Care:
http://
WARNING: The
the homecare setting.
WARNING: If
i
mmediately. DO NOT use
replacement
entrapment,
WARNING: The
limitati
On half Rail is
prevent an individ
Do not use the Clamp-On Half Rail as a
capable of
means of safe restraint.
WARNING: PMI assumes no
caused by
www.fda.gov/cdrh/beds/
on
Important!
or using
any part of these
not
on Bed Rail Safety, please see the
The Facts ” on the FDA website, at…
Probasics
components
parts. N
personal injury, and/or
Probasics
when used with a manual or electric homecare bed. The Clamp-
intended to define the edge of the sleep surface and to help
injuring himself/herself,
improper installation
Read and
Probasics
understand
Model 7035 Clamp-On Half Rail. If you do not
warnings, cautions
direction
in the use of this
properly installed
Hospitals,
7035 Clamp-On Half Rail is designed for use in
are damaged or
substitute
on
Probasics replacement
damage to the Clamp-on Half Rails.
7035 Clamp-On Half Rail has no weight
ual from
inadvertently rolling
responsibility
or use of this pr
these
instructions
or
instructions,
product.
before
contact a
If these Clamp-on
and adjusted, personal injury and/or
following brochure:
Nursing Homes and Home
missing,
parts. Use only
contact your dealer
Probasics
parts could cause
or
climbing
restraint.
In an
individual
consult a physician
out of bed.
for
alternative
is
for any damage or injury
oduct.
1
“A
Probasics
Note: Clamp-On Half Rail may be
angle.
INSTALLATIO
The Clamp-On half Rail CANNOT be
Model 7035 Clamp-On Half Rail Installation
installed
N
on either head deck angle or foot deck
installed
on pan deck.
Movable clamp
Disassembly
Probasics Clamp-On Half
Rail, as shipped, is shown
at near right. Before installation, you must remove and
disassemble the moveable
clamp.
Unscrew the knob from the moveable clamp assembly to separate the knob
and threaded clamp, as shown at far right.
1. Attach moveable clamp jaw
over deck angle, with threaded
rod facing outward, as shown
at near right.
2. Position Half Rail with fixed
clamp jaw toward bed and rails
facing outward, as shown
at far right. Position half rail
mounting slot over movable
clamp threaded rod and slide
until fixed clamp jaw is in-
stalled under deck angle.
3. Install knob on end of movable
clamp threaded rod, as shown
at far right screw on until the
clamp that secures the half rail
to the bed frame is tight.
2
3
RAISE AND LOWER CLAMP-ON HALF RAIL
See Clamp-On Half Rail picture on previous page. To Raise Half Rail: Pull out retainer bar,
raise rail to highest position, and release retainer bar, ensuring that rail is securely trapped by
retainer hooks. To Lowerhalf Rail: Raise rail slightly to release retainer hooks, pull out retainer
bar, lower rail, and release retainer bar.
WARNING: Before use, ensure that the Clamp-On half Rail is assembled and
that all
inspect frequently to ensure that all
Half Rail is se
WARNING: Do not use the Clamp-On Half Rail as a handle for getting into or out of bed; this could
result in
Caution: Do not exert side pressure on the Clamp-on Half Rail; this could deform or break it.
Caution: Do not use the Clamp-On Half Rail as a push handle for moving the bed; this could
deform or
attaching
personal injury and damage to the Clamp-On Half Rail.
break it.
hardware is securely
curely in place.
tightened,
attaching
and that the Clamp-On Half Rail is securely in place;
hardware is securely
tightened,
installed
and that the Clamp-On
as
described,
LIMITED WARRANTY
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH
FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.
This warranty is extended only to the
This warranty gives you
rights
which vary from state to state.
specific
PMI warrants its
two
years for the
product
shall be proven to be defective, such
at PMI's option. This
incurred
obligation
in
and your
repair and/or
whom you
satis
factory warranty service, please write
purchased
page. Provide dealer's name, address, model number, and th
indicate nature of the defect and, if the
number.
product
original purchaser.
warranty does not include any labor or
replacement
exclusive remedy
replacement.
your
to be free from defects in materials and
part installation
For warranty service, please contact the dealer from
Probasics product.
PMI will issue a return
war
ranty
within thirty
inspection
(30) days of return
facility without our
shipping charges.
authorization.
using the serial number, when
authorization
prior consent. C.O.D.
original purchaser/user
of our pr
oducts.
legal rights and you may also have other legal
workmanship
If within such warranty period any such
product
or repair of any such
shall be repaired or replaced,
shipping
product.
charges
PMI's sole
under this warranty shall be limited to such
In the event you do not receive
directly
to PMI at the address on the back
e date of purchase,
product
is serialized, indicate th
e serial
The defective unit or parts must be returned for
applicable,
date. DO NOT return
shipments
will be refused; please prepay
as
identification
products
to our
for
4
LIMITED WARRANTY CONT.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS
ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER
TION, MAINTENANCE OR STORAGE; OR PRODUCTS MODIFIED WITHOUT PMI’S EXPRESS WRITTEN CONSENT INCLUDING, BUT NOT LIMITED TO: MOD
IFICA
THROUGH THE USE OF UNAUTHORIZED PARTS OR ATTACHMENTS: PRODUCTS
DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC CONSENT OF PMI; PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND PMI'
CONTROL; PRODUCTS REPAIRED BY ANYONE OTHER THAN A PMI DEALER, SUCH
EVALUATION SHALL BE SOLELY DETERMINED BY PMI. THE FOREGOING EXPRESS
WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES
WHATSOEVER, WHETHER EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WA
RANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE AND THE SOLE REMEDY FOR VIOLATIONS OF ANY WARRANTY
WHATSOEVER, SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS CONTAINED HEREIN. THE APPLICA
OF ANY IMPLIED WARRANTY WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESS WARRANTY PROVIDED HEREIN. PMI SHALL NOT BE
ABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.THIS
WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/PROVINCIAL LAWS
A
ND REQUIREMENTS.
OPERA
TIO
N
R-
TIO
LI-
-
N
S
15 South Main Street
nd
2
Floor
Marlboro, New Jersey 07746
www.pmiusa.biz
Loading...