Prime Engineering KidWalk II Owner's Manual
OWNER’S MANUAL
KidWalk
II
Dynamic Mobility System
Manufactured By
Prime Engineering
A Division of Axiom Industries, Inc.
11_13KWII_OM_JLD
***Note***
Read Owner’s Manual before use.
Distributed in the:
United Kingdom and Republic of Ireland by
James Leckey Design
19C Ballinderry Road
Lisburn
Co Antrim
Northern Ireland
BT28 2SA
UK: 0800 318 265
ROI: +44 2892 600750
TABLE OF CONTENTS
This owner’s manual is organized into the following sections:
Description Page No.
Table of Contents 2
Product Photo, Specifications and Packing List 3
Intended Use / Restrictions 4
Safety Information 4
Cleaning & Care Information 5
Daily Product Inspection 5
Assembly Information and Instructions 6-9
Measurements & Initial Setup Information 10-11
Initial Adjustments 12
Placing The Client in the KidWalk II 12
Removing The Client 13
Other Adjustments 14-15
Removing the Client and Transport and Storage 16
Annual Product Inspection 17
Reissuing of KidWalk II 17
Product Servicing 17
If you have any questions or require further assistance, please contact your supplying
dealer for assistance or you can contact us directly at Info@primeengineering.com.
**Note:
Carefully read all instructions and notes prior to assembly and use of the
**Note:
KidWalk
II should be used by direction of the clients physician and therapist.**
KidWalk
II.**
KidWalk
II Owner’s Manual
2
SPECIFICATIONS
inch / cm
Seat Ht from floor: 14.5” - 28” 36 - 71.12 cm
Weight Capacity: 90 lbs 40 kg
Product Dimensions:
inch / cm
Base Width: 27.5” 70 cm
Overall Length: 36” - 38” 91.5 - 96.5 cm
Std.Unit Weight: 44 lbs 20.5 kg
Casters: Lighted 5” 127mm
Mast Height: 37.25” 94.6 cm
Upholstery: Black Nylon
PARTS LIST
KidWalk
in 1 carton containing:
Quantity Description
1 Base Assembly
1 Mast Assembly
2 Wheels
2* Axles
2* Axle Spacers
*Axles and axle spacers are in sealed
poly bag enclosed with the unit.
II comes partially assembled
Note: Specifications are for a standard unit.
Optional Items:
Other optional items may be packed with your KidWalk II. Make sure to identify any optional components in the
box and any instruction sheets that go with them.
Mast Assembly
Height Adjust / Release Handle
Fine Adjustment Handle
Load Compensating
Spring Assembly
Mast Tilt Adjust Knob
Wheel Lock
KidWalk
II Component Identification
Headpad
Lateral Chest System
Flip up Front Lateral Pads
Auto Centering Pelvic Guides
Swivel Seat
24” Wheel
Caster
KidWalk
II Owner’s Manual
Anti-tippers
Axle Receiver Locations
Unit shown with some optional components installed.
3
Intended Use and Information
Safety Information
1. Intended Use
KidWalk II is a gait training device that is intended to assist in teaching proper gait with the clients feet on the
floor. The KidWalk II fits children aged approximately 5-12
years old, with a maximum client weight of 40 kg / 90
lbs..
KidWalk II is appropriate for use with any client that fits
within the size restrictions of the unit and has a need for a
supportive device for ambulation. KidWalk II is appropri-
ate for client’s taking their first steps to those clients who
need to learn proper gait technique. Common diagnosis
for use of KidWalk II include but are not limited to, Cere-
bral Palsy, Muscular Dystrophy, Dyplegia, Spinal Muscle
Atrophy, Down’s Syndrome, Spina Bifida and many more.,
2. Restrictions
KidWalk II should be used on smooth even surfaces only.
Maximum seat height on KidWalk II is 71 cm.
Maximum client weight is 40 kg.
3. Warranty
The warranty applies only when the product is used
according to the specified conditions and for the intended
purposes, following all manufacturers’ recommendations
and performing regular service and inspections.
4. Product History Record
Your KidWalk II is a Medical device and as such should
only be prescribed, set up issued or reissued for use by a
technically competent person trained in the use of the
KidWalk II. The manufacturer recommends that a written
record is maintained to provide details of all set ups,
reissue, product inspections and scheduled or annual in-
spections of the KidWalk II.
5. Product Training
(Parents, Teachers & Caregivers)
Your KidWalk II product is a Medical Device and as such
parents, teachers and caregivers using the equipment
should be made aware of the following sections of this
owner’s manual by a technically competent person:
It is also recommended that a written record is recorded
below of all those who have been trained in the correct
use of this product.
Person trained ___________________ Date _________
Trained by ____________________________________
Person trained ___________________ Date _________
Trained by ____________________________________
Person trained ___________________ Date _________
Trained by ____________________________________
Always read instructions fully before use.
Client’s should not be left unattended at any time
while using their KidWalk II.
Only use Prime Engineering manufactured or ap-
proved components or parts with your KidWalk II.
Never modify the product in any way.
Failure to follow instructions may put the client or
caregivers at risk and will void all warranties on the
product.
KidWalk II is not intended to carry the full weight of
the client on the seat as a chair, transport or other
type of activity device other than a gait trainer.
Do Not Use the
vertical movement is supported during gait but
KidWalk
KidWalk
II is not built as a bouncing device.
II as a bouncing device,
If in any doubt to the continued safe use of your
KidWalk II or any of its components, accessories
or parts should fail, Immediately cease using the
product and contact our customer service depart-
ment or your local dealer as soon as possible.
Perform all necessary adjustments and ensure that
they are securely fastened before you put the cli-
ent into the KidWalk II.
While the client is in the frame all safety straps
must be fastened securely.
Never leave the product on a sloping surface, Kid-
Walk II is meant to be used on flat even surfaces.
KidWalk II contains components which could pre-
sent a choking hazard to small children. Always
check that locking knobs and bolts within the
child’s reach are tightened and secure at all times.
Clean the product regularly. Do not use abrasive
cleaners.
Perform maintenance checks on a regular basis to
ensure your product is in good working condition
and that all fasteners are properly tightened.
KidWalk
and when not in use should be stored in a dry
place without temperature extremes.
Never Transport the client in the
II is designed for indoor and outdoor use
KidWalk
II.
KidWalk
II Owner’s Manual
4
Cleaning & Care Information
Cleaning your KidWalk II
When cleaning the KidWalk II we recommend that
you use only warm water and a nonabrasive detergent or a neutral disinfectant. Never use organic solvents or dry cleaning fluids.
Upholstery and fabrics:
1. The upholstery and fabrics can be cleaned by
hand while in place. When cleaning we recommend that you use only warm water and a nona-
brasive detergent.
2. Staining should be removed as quickly as possi-
ble with absorbent cloth, towels or a sponge.
Routine soap and warm water sponging is effec-
tive for ordinary soiling and minor spills.
3. Antiseptic cleaning agents can be used on more
stubborn stains. These may require a safe solvent
such as Isopropyl Alcohol
4. Always ensure the product is dry before use.
Metal and plastic components
1. Soap and water or antibacterial spray can be
used for daily cleaning.
2. For deep cleaning a low pressure steam cleaner
can be used.
3. Do not use solvents to clean plastic or metal
components.
4. Make sure the product is dry before use.
Re-Issue of Product
In many cases, this product may be used and
then returned for use by another client. In
that case the client must be evaluated for
size, function and to make sure that all items
are appropriately sized for the client by an
experienced and trained technician. See
page 17 for Re-Issue information.
Daily Product Inspection
(Therapists, parents & caregivers)
We recommend that daily visual checks of the
equipment are carried out by therapists, caregivers
or parents to ensure the product is safe for use. The
recommend daily checks are detailed below.
1. Check the mast is secured to the base frame and
the pin is in the locked position. Mast Lock Pin
and Knob must be in it’s locked position at all
times during use.
2. Ensure all adjustment knobs and bolts are in
place and secure.
3. Check all upholstery for signs of wear and tear.
4. Check that the wheels are moving freely, wheel
locks function properly, wheels lock securely and
that the axle is fully engaged and wheel assembly
and axles are locked to the frame.
5. Check all Velcro strips and brush fluff to ensure
straps secure firmly. If in any doubt to the continued safe use of your KidWalk II product or if any
parts should fail, please cease using the product and
contact our customer services department or your
local dealer as soon as possible.
6. Make sure anti-tippers are attached securely.
7. Anti-tips must be installed and used at all times
while the
8. Anti-tips must be properly adjusted to the correct
position that matches the position of the large
wheels. See page 6 for additional information.
9. Ensure that the load compensating spring is adjusted correctly and functioning properly as this
provides shock absorption to the
and body support system. See page 12 for adjust-
ment information.
General Maintenance:
Inspect all nuts and bolts weekly and verify
Keep all moving parts free of dirt and grime to
KidWalk
II is in use.
KidWalk
that they are tight and secured properly.
allow for free movement.
II mast
KidWalk
II Owner’s Manual
5
Assembly Information
for your
KidWalk
II
Dynamic Mobility Device
KidWalk
II Owner’s Manual
6
Loading...