PrimeAire PA7010E, PA5010E Use & Care Manual

770-821-6204

Model: PA7010E & PA5010E

TABLE OF CONTENTS

Dehumidier Safety

Installation Requirements

Electrical Requirements

Location Require

ments

Dehumidier Use

Setting the Controls

Draining the Dehumidier

Normal Sounds

Dehumidier Care

Cleaning the Air Filter

Cleaning the Dehumidier

Troubleshooting

3

3

3

4

4

5

7

9

9

10

10

11

2

INSTALLATION REQUIREMENTS

Electrical Requirments

Recommended Grounding Method

This dehumidier must be grounded. This dehumidier is
equipped with a power supply cord having a 3-prong
grounding plug. The cord must be plugged into a mating,
grounding 3-prong outlet, grounded in accordance with
all local codes and ordinances. If a mating outlet is not
available, it is the customer’s responsibility to have a
properly grounded 3-prong outlet installed by a qualied
electrical installer.

It is the customer's responsibility:

To contact a qualied electrical installer.

To assure that the electrical installation is
adequate and in conformance with Nation
Electrical Code, ANSI/NFPA 70-last edition,
and all local codes and ordinances.

Copies of the standards listed may be obtained from:

Nation Fire Protection Association
1 Battery march Park
Quincy, MA 02169-7471

Please recycle or dispose of the packaging material for product in an environmentally responsible manner.

DEHUMIDIFIER SAFETY

Your safety and safety of others are very important

We have provided many important safety messages in this manual and on your appliance. Always
read and obey all safety messages.

You can be killed or seriously injured if you do not
immediately follow instructions.

This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others. All
safety messages will follow the safety alert symbol and either the word “DANGER”
or “WARNING”.

These words mean:

You can be killed or seriously injured if you
do not follow instructions.

All safety messages will tell you what the potential hazards are, tell you how to reduce the chance of injury, and
tell you what can happen if the instructions are not followed.

3

DISPOSING OF THE UNIT
Before disposing of the remote control, it is necessary to remove the batteries and dispose of them in an
environmentally responsible manner.

When you need to dispose of the unit, consult with your local recycling center for information on how to dispose
of the unit in an

environmentally responsible manner.

IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of re, electrical shock ,injury or sickness when using your dehumidier , follow these
basic precautions:

• Plug into a grounded 3 prong outlet.

• Do not remove ground prong.

• Do not use an adapter.

• Do not use an extension cord.

• Unplug dehumidier before servicing.

• Do not drink water collected in the water bucket

SAVE THESE INSTRUCTIONS

Location Requirments

NOTE: Your model may dier from the one shown.

Do not block the louvers.

Allow at least 12” to 18” (30.5 cm to 45.7 cm) of airspace on the
side of the dehumidier for models with side louvers and above
the dehumidier for models with top louvers.
You will need a surface strong enough to support the dehumidier
when its bucket is full of water.
You will need a surface level enough to keep the water from spilling
when the bucket is full of water.
Keep all outside doors, windows and other openings closed when
you are operating the dehumidier. Humid outdoor air will increase
the dehumidier workload.
Install the dehumidier in an area where the temperature will be at

least 38°F (3°C).

Lower temperatures will cause your performance

to decrease.

Dehumidier Use

4