Primax Electronics B81301 User Manual

General Information

Thank you for purchasing PSH-1A Wireless Stereo Headset. Your new device is a stylish

product that enables you to communicate comfortably with compatible mobile phones that

support Bluetooth wireless technology.

WARNING:

Using a mobile phone while driving can distract you and may cause accidents.

Driving with both ears covered may violate Traffic Regulations in certain countries.

Please consult your local authorities.

Getting started

What’s included

(1) Headset (2) User Guide (3) Power adaptor** (4) USB cable**

** depends on customer require

Overview of the headset

(1) Indicator Light

Status indication with blue and red lights

(2) Volume Down button

Decreases the volume

(3) Volume Up button

Increases the volume

(4) Multifunction button

Power on/off, play/pause, answer/end a call

(5) Forward button

Forward to next song

(6) Backward button

Go back to the previous song

(7) Charger connector

Charge the headset

Before using the headset for the first time, you must charge it for approximately 3.5 hours.

When the battery is fully charged, it provides up to 12 hours of talk time, 10 hours of music

playing time and up to 350 hours of standby time. Always use the charger provided in the sales

package.

1. Connect the charger cable to the headset.

2. Plug the charger into a wall socket. The lights turn to solid red in charging status.

3. When the battery is fully charged, the red light will turn off.

Turn on / off the headset

To turn on the headset

Press the Multifunction button for more than 3 seconds. You will hear a long high tone beep

from the earpiece and see blue light on right earpiece flashing three times rapidly.

To turn off the headset

Press and hold the Multifunction button. You will hear a long high tone beep from the earpiece

and see solid red light on for 3 seconds on right earpiece.

Pair the PSH-1A headset and your mobile phone or other devices

You will need to pair your PSH-1A with Bluetooth-enabled mobile phone and/or devices before

you can use it. Your PSH-1A can be paired with up to 8 compatible phones/devices. However,

it can only be connected to one phone at a time.

To pair the headset…

1. Make sure the headset is off. Press and hold the Multifunction button for more than 7

seconds, until you short low tone beeps from the earpiece and the blue and red lights

flashing alternately.

2. Refer to user guide of the phone / device and set the phone / device into pairing mode.

3. When the phone / device finds the headset, PSH-1A will be shown. Please accept and

confirm with the presskey 0000 (4 zeros).

4. Once pair and connection are succeeded, you will hear a short high tone beep and

see blue light flashing. The headset is now ready to serve.

The PSH-1A will automatically reconnect to the last-connected phone / device. If the

connection is failed due to phone / device not found, the headset will automatically enter into

pairing mode.