Candy Floss Maker
Instruction Leaflet
MODEL PCF002
Visit our website at www.prima-international.com
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USING COTTON CANDY MAKER
When using electrical appliances, basic safety precautions should always
be followed including the following:
1. Read all instructions.
2. Do not touch hot surfaces.
3. To protect against fire, electric shock and personal injury, do not
immerse cord, plug or cotton candy maker in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near
children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off bowl and extractor head assembly.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, or has been damaged in any manner.
7. Do not use outdoors.
8. Do not let cord hang over edge of table or counter, or touch hot surface.
9. Do not place on or near a hot gas or electric burner, or in a heated oven.
10. Extreme caution must be used when moving an appliance containing
hot liquids.
11. Always attach plug to appliance first, then plug cord into the wall outlet.
To disconnect, turn all controls to “off” then remove plug from wall outlet.
12. Do not use appliance for other than intended use as described in this
manual.
13. If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazard.
THIS APPLIANCE HAS HOT MOVING PARTS, PLEASE BE EXTRA
VIGILANT WHEN USING AROUND CHILDREN.
COMPONENTS
Extractor Head Assembly
Switch
Bowl
Protective Housing
Paper Cone
OFF
ON
Body
Power Cord
OFF
ON
PREPARING TO USE
1. Take the cotton candy maker out of the cardboard case and remove all
packing materials.
2. Wash extractor head assembly and bowl in warm water.
3. Align hooks of the body with the openings of the bowl. Turn bowl anti
clockwise to lock bowl to the body. (A)
4. Install the extractor head assembly. Be sure to push the extractor head
downward firmly to seat properly. Improper seating of the extractor head
assembly may result in failure to produce cotton can dy or will result in
excessive vibration. (B)
5. Operate the unit on a flat level surface.
6. Plug the power cord into a suitable 220-240V AC outlet.
A
B
O
F
F
ON
OFF
N
O
HOW TO USE
1. Switch on the unit for 5-8 minutes, allow it to warm up then switch off.
2. Place two scoops of pure granulated sugar into the center of the extractor
head to be spread evenly (please use the scoop supplied with the unit, or
you may use one level tablespoon). (C)
NOTE
• Do not put more than two measures of sugar. Excessive sugar causes
noise and vibration.
• USE ONLY PURE GRANULATED SUGAR FOR THIS COTTON CANDY
MAKER.
• Use of other sugar may fail to produce cotton candy.
• Do not use sugar mixed with other materials such as coffee or dry
milk. It will cause a blockage of the extractor head.
• Never use materials other than pure granulated sugar, such as salt.
C
O
FF
ON
3. Switch control to ON. Extractor head rotates and is heated by the heater
element.
4. Cotton candy comes out about 4 or 5 minutes after turning unit on.
Wind cotton candy on the paper cone (packed with unit) as follows:
With the paper cone in vertical position, turn the paper cone along the
inside of the bowl several times. Then lay the paper cone horizontally
and rotate it above the extractor head to wind cotton candy. (D)(E)
5. After cotton candy is made, switch unit off.
6. To make more cotton candy, repeat the above sequence. After the initial
process of making your first lot of candy floss, the repeated process time will
only be about 3-4 minutes.
NOTE:
Sugar should only be put in after the extractor head stops completely.
D
OFF
N
O
E
OFF
N
O
CAUTION
• Do not put sugar in the extractor head when the switch is turned ON.
• Make sure to switch off after cotton candy has been made. When the
cotton candy maker is used with sugar remaining from prior use in the
extractor head, there may be an imbalance of the extractor head. This
may cause noise or vibration of the unit, with resulting damage to the unit.
• The extractor head rotates under high temperature and high speed.
reduce the risk of injury, never touch with hands, spoons or other things.
• The temperature of the extractor head is still high for a short pe riod
(approximately 15 minutes) after the extractor head has stopped. Keep
hands off to reduce the risk of burn.
• After turning unit off, wait for extractor head to stop. Do not stop with
paper cone or spoon. It may cause injury or damage to the unit.
• Be sure the bowl is attached when in use.
• Do not use on a carpet.
• Do not put hands in bowl while operating.
• Do not place your face too close to the bowl while operating.
• Use the cotton candy maker within the room temperature range of 50
degrees F – 95 degrees F (10C - 35C). Cotton candy may not be
produced with the room temperature beyond the range.
• Do not use the cotton candy maker in a place where wind from a fan or air
conditioner hits directly on the maker, since cotton candy will not be
wound well.
• Do not use in a room containing valuable pictures or a chandelier, since
the cotton candy may be blown up.
• When carrying the c otton candy maker, always hold the body not the
bowl.
• Do not switch “ON” the cotton candy maker without the extractor head in
place.
MAINTENANCE
1. Switch off and disconnect the power cord when not in use.
2. Clean the bowl and extractor head according to “HOW TO CLEAN”.
3. Use a soft cloth to clean the body and protective housing. Do not
brush, since any kind of brush is likely to scratch the surface of these parts.
4. Install the bowl and extractor head as it was originally.
CAUTION
• Do not clean any part of the cotton candy maker with gasoline,
kerosene, glass or furniture polish or paint thinner.
• Do not spray any water on the body. There is a risk of electrical
shock and damage to the unit’s electrical components.
• Do not unplug the unit if your hands are wet. Electrical shock could
occur.
HOW TO CLEAN
CLEANING THE BOWL
1. Turn the bowl clockwise to detach from the body.
2. Wash the bowl with cold or warm water. Use a soft cloth to wash.
A scrubbing brush will scratch the surface of the bowl. Dry the surface
completely.
CLEANING THE EXTRACTOR HEAD ASSEMBLY
CAUTION: The extractor head assembly is still hot for about 15 minutes
after turning off. Remove the extractor head after it becomes cool to avoid
the risk of burn.
1. Wash the extractor head assembly with hot warm water. Soak it in
water before washing to make it easier to clean. Use soft cloth to clean.
A scrubbing brush will scratch the surface.
2. Dry the extractor head assembly completely.
NOTE: Be careful in handling the extractor head. Do not drop or bend it.
Sugar deposits can be loosened quickly by immersing the extractor head
assembly in very hot water.
MAKING COLOURED CANDY FLOSS
ONLY USE APPROVED POWDERED FOOD COLOURING IN THE
CANDY FLOSS MAKER.
1. Put 1 measure of sugar into a small cup.
2. Using the other end of the measuring spoon, add a small amount of
the food colouring to the sugar.
3. Gently shake the cup to mix the sugar and colouring.
4. Pour into the extractor head as normal as per instructions.
Suitable Edible Food Dust is available in a variety of colours including Pink, Blue, Red,
Green, and Yellow from Squires Kitchen Sugarcraft, Farnham, Surrey, UK
Order online at www.squires-shop.com or by phone on 00 44 (0)1252 727572.
U.K. PLUG WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following
code:
BROWN - LIVE (L)
BLUE - NEUTRAL (N)
GREEN/YELLOW - EARTH (E)
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
• The BLUE wire is the NEUTRAL and must be connected to the terminal
which is marked with the letter N or coloured BLACK
• The BROWN wire is the LIVE and must be connected to the terminal
which is marked with the letter L or coloured RED.
• The wire which is coloured GREEN/YELLOW must be connected to the
terminal which is marked E or coloured GREEN or GREEN/YELLOW.
Always ensure that the cord grip is positioned and securely fastened.
WARNING: THIS APPLIANCE MUST BE EARTHED.
If a 13A (BS1363) fused plug is used it must be fitted with a 13A fuse. If in
doubt consult a qualified electrician.
WIRING FOR A 13AMP PLUG
(GREEN & YELLOW)
EARTH
LIVE
13 AMP
NEUTRAL
(BLUE)
(BROWN)
~~~~~ Warranty ~~~~~
This product is guaranteed for 12 months from the date of purchase when the
appliance is used solely for domestic purposes. For commercial use the product is
guaranteed for 90 days from the date of purchase.
The guarantee is valid against mechanical or electrical defects if the product is used
in accordance with the instructions and provided that it is not connected to an
unsuitable electricity supply or dismantled, interfered with or damaged in any way.
IMPORTANT, PLEASE RETAIN THIS WARRANTY
Please ask your retailer to either stamp this warranty or simply attach your
store receipt. Keep this warranty somewhere safe. DO NOT SEND TO PRIMA.
This guarantee in no way affects your rights under statutory law.
IF THE PRODUCT MALFUNCTIONS DURING ITS WARRANTY PERIOD IT MUST
BE RETURNED TO THE RETAILER FROM WHOM IT WAS PURCHASED FOR
REPLACEMENT. IF YOU BOUGHT THIS PRODUCT VIA MAIL ORDER, PLEASE
KEEP ALL THE DOCUMENTATION THAT CAME WHEN THE UNIT WAS
DELIVERED.
NAME____________________________________________________________
ADDRESS_________________________________________________________
__________________________________________________________________
PURCHASED FROM_________________________________________________
DATE OF PURCHASE ___________________MODEL_____________________
Prima International Plc, Prima House, Premier Park, Oulton, LEEDS LS26 8ZA
United Kingdom
© Copyright 2002 Prima International PLC. All rights reserved.
.
Loading...