Prima PCC650C User Manual

Stainless Steel Jug Kettle

MODEL: PCC650C

Instruction Book

Visit our web site at: www.prima-international.com

How To Use Your Coolwall Kettle

To fill the kettle press the lid release button to open the f lip top lid. This kettle is designed with a
fill through Spout, and water may be poured through the spout to fill.

• Put in at least enough water to cover the bottom of the kettle but never more than the ‘MAX’
mark.

• To close the lid, press the lid down until it clicks into place.

• DO NOT OPERATE THE KETTLE WITH THE LID OPEN.

• Place the kettle on the base unit, engaging the 360 degree base unit connector. The rotary

type base unit allows you to place the kettle in any convenient position.

• Plug in and switch ‘ON’ at the wall socket.

• Press the ON/OFF switch lever down to switch ‘ON’. The incorporated neon ‘ON’ light will

illuminate indicating that the kettle is working.

• When the water boils, the kettle will switch ‘OFF’ a utomatically – the switch lever will
automatically return to the ‘up’ or ‘OFF’ position.

• If, during the boiling process, the kettle is lifted off its base, it will automatically switch ‘OFF’.

• To remove the kettle from the base unit, grasp the cool touch handle and hold the kettle level

while lifting it clear off the base unit. Take extra care if the kettle is filled to the ‘MAX’ level.

• If you are using the kettle for the first time, fill to the ‘MAX’ mark, boil and pour away the
boiled water – then refill. This will remove any manufacturing residue that may have
collected.

• To re-boil, switch ‘ON’ again. If the kettle has just switched ‘OFF’ wait approximately 30
seconds before switching it back ‘ON’ again.

• If you do not put enough water, or if you switch the kettle ‘ON’ when it is empty, the safety
cut-out will switch ‘OFF’ the power automatically. If this happens, wait a few minutes for the
element to cool, then refill and use as normal.

• IMPORTANT: The kettle must ONLY be used with the base unit provided.

• IMPORTANT: This kettle is NOT to be filled while it is still located on the base unit.

Important Safeguards

When using t he electrical appliances, basic safety pr ecautions sh ould always be followed,
including the following:

• Check that the mains voltage corresponds with the rating of the appliance before operating.

• Do not touch hot surfaces – Use handles or knobs.

• To protect against electric shock, do not immerse cords, plugs or appliances in water or any

other liquid.

• Do not leave any appliance unattended while it is operating.

• Close supervision is necessary when any appliance is used by or near children or infirm

persons.

• Unplug from outlet when not in use or before cleaning. Allow to cool before putting on or

taking off any parts.

• Do not operate the appliance with a damaged cord or plug, or after the appliance has been

damaged in any manner. If the supply cord or appliance is damaged, the manufacturer or its
service agent or a similarly qualified person must replace it in order to avoid a hazard.

• The use of accessory attachments not recommended by the appliance manufacturer may

cause injuries.

• Do not use outdoors.

• Do not let the cord hang over the edge of a table or counter or let it come into contact with

any hot surfaces.

• To disconnect – remove the plug from the outlet. Do not pull plug out by the cord.