Pride Mobility INFINFB2804 User Manual
PRODUCT SPECIFICATIONS SHEET
Model: Jazzy Elite 6
Manufacturer: Pride Mobility Products Corp.
Internet Address: www.pridemobility.com
Document Information: INFINFB2804/Rev B/October 2012
Weight Capacity: 300 lbs. (136 kg)
Maximum Speed:
Ground Clearance:
1
2
Up to 3.7 mph (6 km/h)
2.5 in. (6.35 cm) at battery box
1.875 in. (4.76 cm) at caster arm spring
Turning Radius:
Overall Size:
2, 6
2
25 in. (63.5 cm)
Length: 41.5 in. (105.4 cm) with front riggings
36.5 in. (92.7 cm) without front riggings
Width: 23.25 in. (59 cm)
Drive Wheels: 9 in. (22.86 cm), solid
Caster Wheels: Rear: 6 in. (15.24 cm), solid
Front: 5 in. (12.7 cm), solid
Suspension: Limited
Range:
1, 4
Component Weights:
5
Up to 12.04 miles (19.37 km)
Base: 79 lbs. (35.8 kg)
Standard Seat and Controller: 52.5 lbs. (23.8 kg)
Batteries: 21 lbs. (9.5 kg) each
Drivetrain: Two motor, front-wheel drive
Brakes: “Intelligent Braking” electronic regenerative, disc park brake
Batteries:
3
Two 12-volt, U-1 batteries
Battery Charger: 3.5-amp, off-board
Maximum Allowable Incline: 6° (10.5%)
Maximum Angle Capacity: 10° (17.6%)
Maximum Obstacle Climbing Ability: 2 in. (5 cm)
1
Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery condition, motors,
controller type, tire type, and tire condition. This specification can be subject to a variance of +10%, -5%.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of
(+ or -) 3%.
3
AGM or Gel-Cell type required. See VI. “Batteries and Charging.”
4
Tested in accordance with ANSI/RESNA WC Vol 2, Section 4 and ISO 7176-4 Standards. Results derived from
theoretical calculation based on battery specifications and drive system performance. Test conducted at maximum
weight capacity.
5
Battery weight may vary based on manufacturer.
6
Dimensions listed are for power base only. Overall measurements will vary based on seating and accessory selections.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176 series EN12184
standards. All specifications subject to change without notice.
*INFINFB2804*
LENGTH (WITH FRONT RIGGINGS)
41.5 in. (105.4 cm)
LENGTH (WITHOUT FRONT RIGGINGS)
36.5 in. (92.7 cm)
2.5 in. (6.35 cm)
GROUND CLEARANCE AT BATTERY BOX
TURNING RADIUS
WIDTH
23.25 in. (59 cm)
1.875 in. (4.76 cm) GROUND CLEARANCE AT CASTER ARM SPRING
25 in. (63.5 cm)
*INFINFB2804*
Loading...