![](/html/07/07b1/07b151a0a27aa225be1c56e170a0cd100e78ae3ce587794b3fe3effc79d71a43/bg1.png)
MANUAL – INSTALLATION + SERVICE
Exposed Displacement Diffuser
DFE Series
Revision: v001 – Issue Date: 06/03/19
© 2019 Price Industries Limited. All rights reserved.
![](/html/07/07b1/07b151a0a27aa225be1c56e170a0cd100e78ae3ce587794b3fe3effc79d71a43/bg2.png)
12”
ANGLE MOUNTING
= NOM WIDTH -1.5”
FLOOR
WALL BY
OTHERS
MOUNTING ANGLE
1
1
12”
ANGLE MOUNTING
= NOM WIDTH -1.5”
FLOOR
WALL BY
OTHERS
MOUNTING ANGLE
1
1
A
5
Detail B
TOP
WITH DUCT COVER
B
12”
ANGLE MOUNTING
= NOM WIDTH -1.5”
FLOOR
MOUNTING ANGLE
EXPOSED DISPLACEMENT DIFFUSER
INSTALLATION INSTRUCTIONS
DFE W/DUCT COVER
1. Remove trim cover (Item 4) by putting finger in opening
(Detail C) at top or bottom and pulling slowly to prevent
bending of trim piece. Keep close for use in final step of
installation.
2A. Mounting angles are shipped attached to the diffuser.
Remove two screws holding the mounting angle to corner
extrusion (Section E-E).
2B. Locate and install 1" x 1" x .100" mounting angles to the
wall in desired location. The mounting angles shall be
installed perpendicular to the floor as per Figure 1 and
spaced apart as per dimension given in Table 2. Failure to
position angles upright and perpendicular to the floor will
result in poor installation. Fasteners supplied by others.
3. Install diffuser (Item 2) over the mounting angles so that
the back of the diffuser is flush with the wall (see Figure
3,4 & 5). Fasten to mounted angles with screws (Item 5).
Use minimum 2 screws per side of diffuser.
4. Attach duct to diffuser inlet.
5. Install next section of mounting angle for the duct cover in
line with diffuser mounting angles. If this is the last section
of duct cover cut the extrusion to fit 1" below the ceiling
height or the height of the duct cover.
6. Tap trim cover into place with rubber mallet or neoprene
hammer. Care should be taken not to mark/damage trim
cover, diffuser or surrounding wall.
7. Detailed installation instructions are also available on video
at priceindustries.com.
FIGURE 1
WALL BY
OTHERS
FIGURES 3 & 4
2
12”
FRONT
1
ANGLE MOUNTING
= NOM WIDTH -1.5”
MOUNTING ANGLE
1
FLOOR
SIDE
FIGURE 2
Detail A
FIGURE 5
TOP
B
A
Detail B
5
1
EXPOSED DISPLACEMENT DIFFUSERS - Manual | priceindustries.com
WITH DUCT COVER