Presto SaladShooter electric slicer/shredder Instructions Manual
SaladShooter
electric slicer/shredder
Slices or shreds vegetables, fruit, and cheese.
Just point and shoot right where you want.
Cleanup is easy. Dishwasher safe. Stores anywhere.
Visit us on the web at www.GoPresto.com
2006 by National Presto Industries, Inc.
INSTRUCTIONS
This is a Listed appliance. The following important safeguards are recommended by most portable appliance
manufacturers.
IMPORTANT SAFEGUARDS
To reduce the risk of personal injury or property damage when using electrical appliances, basic safety precautions should always be followed, including the following:
1. Read all instructions before using this appliance.
2. To protect against the risk of electrical shock, never put the motorized base, cord, or plug in water or other liquids.
3. Close supervision is necessary when any appliance is used by or near children.
4. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.
5. Do not operate any appliance with a damaged cord or plug, or in the event the appliance malfunctions, or is dropped or
damaged in any manner. Return the appliance to the Presto Factory Service Department (see page 5) or to the nearest Presto
Authorized Service Facility for examination, repair, or electrical or mechanical adjustment.
6. The use of attachments not recommended or sold by the appliance manufacturer may cause fire, electric shock, or injury.
7. Do not use outdoors.
8. Do not let cord hang over edge of table or counter or touch hot surfaces, including the stove.
9. Avoid contact with moving parts.
10. Never feed the food through the food chamber with your hands; always use the food guide.
11. Keep fingers out of the slicing/shredding chute.
12. The metal portions of the slicing and shredding cones are sharp. Handle with care.
13. Do not use the slicer/shredder for other than intended use.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
1
IMPORTANT SAFETY INFORMATION
Connect the power supply cord to a polarized outlet only. As a safety feature, this appliance has a polarized plug (one blade
is wider than the other). This plug will only fit in a polarized outlet one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
Getting Acquainted
Before using your electric slicer/shredder,
study the diagram to the right to become
familiar with the various parts of the unit and
read the instructions carefully.
Food
chamber
Before initial use, and after each subsequent
use, wash all parts except the motorized base
in warm, sudsy water. Wipe the motorized
base with a damp cloth to clean. Never immerse the motorized base in water or any
other liquid.
Slicing/shredding
chute
Driving
end
How To Use Your Slicer/
Shredder
1. Select the slicing or shredding cone and
insert it, narrow end first, into the slicing/
shredding chute (Fig. A). Then attach the
twist-lock ring by turning clockwise until
it locks into place (Fig. B). The metal portions of the slicing and shredding cones are
sharp. Handle with care.
2. Attach the food chamber assembly to the
motorized base. With the food chamber
assembly held at an angle, fully insert the
driving end of the assembly into the socket
of the motorized base (Fig. C). Next, while pushing the food chamber
assembly firmly in towards the handle, rotate the assembly clockwise
until it is upright and it is centered with the handle.
Check to be sure that the interlock bracket on the food chamber
assembly (Fig. D) has been fully captured in the bracket slot located
at the front of the motorized base (Fig. E). If it is not captured, the
unit may not operate and the food chamber assembly will fall off
the base.
3. Plug cord in and load the food chamber.
For best slicing and shredding results,
it is important that the food be prepared
properly and placed in the food chamber
as follows:
Cut food so that it will fit easily and
loosely into the food chamber. Food
that does not fit loosely in the food
chamber may become wedged in the
food chamber and therefore will not
discharge properly. If it is too large to
fit loosely in the food chamber, cut it
into smaller pieces.
Shredding
cone
Slicing
cone
Bracket slot
Fig. C
Rotate the food chamber assembly clockwise making sure the
interlock bracket engages with the bracket slot.
Socket
Driving
end
Interlock
bracket
Slicing/
shredding chute
Fig. D
ON-OFF
latch
Fig. A
Food
chamber
assembly
Twist-lock ring
Food
chamber
assembly
Twistlock ring
Interlock
bracket
Slicer/shredder
power switch
Bracket
slot
Fig. E
Motorized
base
Interlock
bracket
Bracket slot
Food guide
Fig. B
2
Loading...