Presto 9402 User Manual
mypod
refillable coffee holder
(model 09402)
Replaces the Philips* Senseo* model HD7810/15,
HD7810/65, and HD7810/75 pod holder.
INSTRUCTIONS
Before using the Presto MyPod refillable coffee holder with your Philips* Senseo* pod coffee maker, be sure the coffee maker
is in good working condition.
Important Information
1. Your coffee maker is not designed to brew all grinds
of coffee. It is instead designed for use with the
pods that accompany the unit. You can enjoy similar
results by using a drip coffee maker grind when
using the Presto
If you grind your coffee from beans, be sure that
the texture feels no coarser than table salt and no
finer than sugar. You can tell by the coffee produced
if you have the right grind; if too fine, little or no
coffee will be dispensed; if too coarse, a weaker than
desired brew will be produced.
2. Your coffee maker will dispense more coffee with
the Presto
does when using the pods that accompany the unit. Depending on the size of the cup used, it may
overflow.
Note: We recommend that you remain by the coffee maker during the brew cycle. You can
stop the flow at any time, by pressing the indicator light button on the coffee maker.
3. When using the Presto
crème.
MyPod refillable coffee holder.
MyPod refillable coffee holder than it
MyPod refillable coffee holder, your coffee maker will not produce
Retractable
lifting pin
Compacting
cover
*Senseo and Philips are trademarks of Koninklijke Philips Electronics N.V. LTD. LIAB. CO.
National Presto is not affiliated with that company.
Refillable coffee holder
Coffee filter
Coffee scoop
Fig. A
2006 by NPI, Inc.
1
⁄2 fill line
Fig. B
Flat
side up
Brewing Coffee
Before first use, wash the coffee scoop, refillable coffee holder, and compacting cover in warm, soapy
water. Rinse thoroughly.
1. Place a Presto
prevent slippage inside the holder.
2. Using the coffee scoop (Fig. A), pour 1 to 1
coffee holder. Use 1 scoop for normal strength coffee and 1
use more than 1
Using a damp paper towel, brush off any coffee grounds on the rim of the holder before placing the holder in the coffee
maker.
Use a drip coffee maker grind NOT an espresso grind of coffee. If you grind your own coffee, it should have a texture
which feels no finer than sugar and no coarser than table salt.
3. Position the compacting cover over the coffee grounds so the flat side is facing up (Fig. B) and push it down firmly and
completely to compact the coffee grounds. Depress retractable lifting pin before use.
4. Remove the pod holder that came with your Philips* Senseo* pod coffee maker. Replace it with the Presto
coffee holder (Fig. C) and follow the manufacturer’s instructions for brewing coffee.
MyPod coffee filter in the refillable coffee holder. Moisten the filter slightly to
1
1
⁄2 scoops of coffee.
⁄2 scoops of ground coffee on the filter in the refillable
1
⁄2 scoops for stronger coffee. Do not
1
MyPod refillable
Fig. C
Removing and Cleaning Holder
1. Your Philips* Senseo* coffee maker operates under high pressure. After coffee is done brewing, before opening unit, wait
approximately one minute to allow pressure to reduce and excess water to drain through unit. It is normal for a small amount
of dripping to occur once the brewing cycle is complete.
2. Slowly open lid on your coffee maker and using the handle, carefully remove the coffee holder from the coffee maker. Use
caution when removing coffee holder from coffee maker as there may still be some hot water/coffee in holder that may
drip. Let coffee holder cool down or run coffee holder under cold water and then lift off compacting cover using the retractable
lifting pin (Fig. A). Discard coffee grounds.
3. Rinse the coffee scoop, refillable coffee holder, and compacting cover in hot water. Occasionally wash parts in warm, soapy
water and rinse. If using a dishwasher, place all parts in the utility or utensil basket.
Questions & Answers
I like really strong coffee. How can I make it with the Presto MyPod refillable coffee holder?
Use a finer grind – one having the texture that feels like sugar. When making coffee, use 1
rather than the two cup button. If coffee still isn’t strong enough, reduce the amount of liquid dispensed by pressing the indicator
light button on the coffee maker before the cycle ends.
The cup overflowed and coffee spilled all over the counter. What am I doing wrong?
Your coffee maker is calibrated to push water at a specific pressure through a coffee pod for a specific period of time. Coffee placed
in the MyPod
to prepare coffee with the MyPod
refillable coffee holder has different flow characteristics than a coffee pod. As a result, more water than is needed
holder may be forced through the grounds. It is thus recommended that you remain by the
coffee maker during the brew cycle and, if it appears that the cup will overflow, stop the flow of water by pressing the indicator
light button.
Minimal or no coffee was dispensed? What is wrong?
The coffee you are using is ground too fine – it is intended for espresso rather than coffee. Your coffee maker does not have enough
pressure to force the water through coffee ground so fine. Use a drip coffee maker grind – if you grind your own coffee, the ground
texture should feel no finer than sugar and no coarser than table salt.
The coffee maker leaks at the sides behind the spout. How do I get it to stop?
You may be using coffee that has been ground too fine or there may be coffee grounds on the rim of the holder. Use a coarser grind
of coffee, one that is no finer than sugar, and be sure to brush off any grounds from the rim of the holder before placing it in the
coffee maker.
My coffee contains a lot of sediment. Is this normal?
You may have forgotten to clean the grounds off the rim of the holder after you poured in the ground coffee. Be sure to wipe off
the rim before inserting the holder in the coffee maker.
Note: You may see a small amount of very fine sediment at the bottom of the cup. This is normal.
1
⁄2 scoops and press the one cup button
Consumer Service Information
In the event you encounter a problem with the coffee maker, replace the refillable coffee holder with the pod holder that came with
your coffee maker and follow the manufacturer’s instructions. If the problem persists, it is not due to the Presto
coffee holder. Contact the coffee maker manufacturer.
If you have any questions regarding the operation of your Presto
appliance or need parts for your appliance, call our Consumer
Service Department weekdays 8:00 AM to 4:30 PM (Central Time) at 1-800-877-0441 or write:
NATIONAL PRESTO INDUSTRIES, INC.
Consumer Service Department
3925 N. Hastings Way
Eau Claire, WI 54703-3703
You may also contact us at our website www.GoPresto.com. Inquiries will be answered promptly by telephone, letter, or email.
When writing, please include a phone number and a time when you can be reached during weekdays if possible.
Any maintenance required for this product, other than normal household care and cleaning, should be performed by our Factory
Service Department. Be sure to indicate date of purchase and a description of defect when sending an appliance for repair. Send
to:
CANTON SALES AND STORAGE COMPANY
Presto Factory Service Department
555 Matthews Drive
Canton, MS 39046-0529
2
MyPod refillable
Loading...