Warning - To reduce the risk of fire, electric shock, or injury to
persons, observe the following:
1. Use this unit only in the manner intended by the manufacturer. If
you have any questions, contact the manufacturer.
2. Before servicing or cleaning unit, switch power off at service
panel and lock service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by qualied
person(s) in accordance with all applicable codes and standards,
including re-rated construction.
4. Sufcient air is needed for proper combustion and exhausting
of gases through the ue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into a wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
DANGER: Turn off the power circuit breaker or the power
switch on the junction box before installing or servicing
this unit. Touching circuitry inside the range hood while it is
energized will result in death or serious injury.
DANGER: All electrical wiring must be properly installed,
insulated, and grounded. Improper insulation and grounding
will result in deadly electrical shock.
DANGER: If installing this unit over a gas range, turn off
the gas at the source before installing or servicing this unit.
WARNING: Attempting to install or service this unit
when you do not have the necessary technical or electrical
background could result in personal injury.
WARNING: The unit has sharp edges. Always wear safety
gloves during installation, cleaning, or servicing.
WARNING: Always leave safety grills and lters in place.
Without these components, operating fans could catch on to
hair, ngers, or loose clothing.
WARNING: Stay clear of the rotating fan when the motor
is running.
2
WARNING: Keep this appliance clean and free of grease
and residue build-up at all times to prevent res.
CAUTION: This device is for general ventilating use only.
Do not use to exhaust hazardous or explosive materials and
vapors.
Safety Information (continued)
Cooking Safety Information
1. Never leave the range hood unattended when in use.
2. Never cook over open ames under the range hood.
3. Always turn the range hood on when cooking at high heat
or when cooking aming foods.
4. If you choose to hang the range hood as below (Fig. 1) distance
(D) from the cooktop surface, use extra caution as the surface of
range hood may be extremely hot to the touch.
For QR015 (D in Fig. 1) is 711 mm - 813 mm (28 in. - 32 in.).
For QR060, (D in Fig. 1) is 458 mm - 813 mm (18 in. - 32 in.).
The closer you install to the cooktop (within the recommended
distances) the hotter the range hoods surface temperature will
become when cooking for an extended period amount of time.
5. Use caution when cooking with oil or with deep-fryers.
Overheating may cause oil to reach its ash point and ignite.
Used oil will ignite at lower temperatures than fresh oil. Heat
oils slowly on low to medium setting.
6. Avoid boil overs, as they may cause smoking and greasy
spillovers that could ignite.
7. To prevent burns or res, always use cookware appropriate to
the size of the heating element that you are using.
8. In event of a cooking re, observe the following:
- Be careful to avoid burns.
- Smother ames with a close-tting lid, cookie sheet, or
metal tray, then turn off the burner. If the ames do not go
out immediately, evacuate and call the re department.
- Never pick up a aming pan.
- Do not use water, including wet dishcloths or towels, as you
could cause a steam explosion.
- Use an extinguisher only if: (a) you have a class ABC
extinguisher and you know how to operate it, (b) the re is
small and contained in the area where it started, (c) the re
department is being called, and (d) you can ght the re with
your back to the exit.
Cleaning Safety Information
1. The fan and lters must be cleaned periodically and kept free
from accumulation of cooking residue. Old and worn lters must
be replaced immediately.
2. Never disassemble parts to clean. Parts should be disassembled
by qualied persons only.
WARNING: To reduce the risk of re, use only metal duct
work. Never use plastic duct work.
WARNING: To reduce the risk of re or electric shock, do
not use this range hood with any external solid state speed
control device.
CAUTION: For general ventilation use only. Do not use the
range hood fans to exhaust hazardous or explosive vapors.
CAUTION: Never dispose of cigarette ashes, ignitable
substances, or any foreign objects in fans.
CAUTION: At least two people are needed to move and
safely install the unit. Failure to properly lift the range hood
could result in product damage or personal injury.
D
Fig. 1
3 CONGLOMKB.COM
Please contact 1-877-333-0098 for further assistance.
Warranty
ONE YEAR LIMITED WARRANTY
A thorough inspection must be made before installation and any damage must be promptly reported. We will not be liable for failures or
damage that could have been discovered or avoided by proper inspection and testing prior to installation.
Conglom Kitchen & Bath warrants this product to be free from defects in materials or workmanship for one (1) year from the date of purchase.
Proof of purchase (original sales receipt) from the original consumer purchaser must be made available to Conglom Kitchen & Bath for all
warranty claims.
This warranty is non-transferable and shall be voided if the unit is removed from its initial installation or if it is not installed following the
manufacturer’s instructions. It does not apply in the event of product damage due to the use of other than genuine Conglom Kitchen & Bath
replacement parts, (Replacement parts may be obtained by calling 1-877-333-0098 between 8:30 am - 5:00 pm EST) installation error, abuse,
misuse or improper care and maintenance (whether performed by a plumber, contractor, service provider or member of the purchaser’s
household). The warranty excludes damage due to aggressive air or water conditions, harsh or abrasive cleaners and/or materials.
Under no circumstance shall we be held liable for personal injury or property damage resulting from improper installation or use of this
product. We will not be held liable for inconvenience caused by loss of use of this product, costs incurred for labour or materials, removal
and installation of replacement units, or any other incidental or consequential damages. Costs relating to obtaining access for repair or
replacement are the responsibility of the user.
Our obligation shall be limited to the repair or replacement of a unit (at our discretion) that may prove, by our sole examination, to be defective
under normal use and service during the warranty period.
Any failure of this product that is not traceable to a defect in material or workmanship is not covered by this warranty. These non-warrantable
items include, but are not limited to:
- Improper installation not in accordance with manufacturer’s instructions.
- Dents and/or scratches incurred during shipping, handling, or installation.
- Change in colour or nish due to chemical usage.
- Damage caused by failure to follow care and cleaning guidelines, including damage caused by the use of abrasive cleaners.
- Alterations made to the unit by the purchaser or installer.
- Damage caused by accidental impact, re, ood, freezing, and normal wear.
- Bends and warping caused by forced connections, over-tightened ttings, and inadequate support during installation.
- Any defects or damage to light bulbs.
This warranty does not extend to commercial and institutional installation or use.
WARRANTY CLAIM PROCEDURE
If a claimable defect occurs or replacement parts are needed, please contact our customer service team at 1-877-333-0098 (8:30 am - 5 pm,
EST, Monday–Friday).
Before you make your call, please ensure that you have:
- Model number or description of the range hood.
- Proof of sale.
- Details regarding the defect and/or part number.
- Name(s) and address(es) of the owner and installer.
4
Pre-Installation
TOOLS REQUIRED
Measuring tape
Marker or pencilTape
Phillips screwdriver
Hammer
LevelUtility knife
Flathead
screwdriver
Electric drill
or powered
screwdriver
Adjustable
wrench
Needle nose
pliers
Safety gloves
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
ModelPartDescriptionQuantity
QR015CCLong tapping screw - (M5 mm x 30 mm)4
ModelPartDescriptionQuantity
AALong tapping screw - (M5 mm x 12 mm)6
QR060
BBScrew - (M4 mm x 16 mm)8
Safety gloves
AACC
AABB
5 CONGLOMKB.COM
Please contact 1-877-333-0098 for further assistance.
Pre-Installation (continued)
PACKAGE CONTENTS
AB
C
ModelPartDescriptionQuantity
QR015ARange Hood1
ModelPartDescriptionQuantity
QR060
6
BRange Hood1
CDuct Set1
Pre-Installation (continued)
PLANNING INSTALLATION
Number of people required: 2 or more
Carefully check the range hood for damage and for missing parts prior
to installation. If there is any damage or if you are missing parts, do
not proceed with the installation. Report damage and missing parts
immediately. Do not dispose of packaging before you are satised with
your new range hood.
1. Before installation, measure all distances to ensure the proper position
of the range hood (A).
- The distance (1) from the cooking surface to the range hood must
be at least 18 in. (458 mm) for QR060, for QR015 the minimum
distance is 28 in. (711 mm). For the best performance, do not
install the range hood more than 32 in. (813 mm) above the
cooking surface.
- Dimension (3) should be at least 30" (762 mm). The range hood
should be approximately the same size as the cook top.
2. If the bottom of the cabinet (6) above the location where the range hood
is to be installed is recessed, attach appropriately sized wood ller strips
(7) on each side using wood screws.
3. Screws are provided to secure the range hood to most types of cabinets,
but consult a qualied installer to verify that the supplied screws are
suitable for your cabinets.
4. Put a thick, protective covering over your counter, cooktop, or range
to protect it from damage and dirt during installation. Remove any
hazardous objects around the area.
WARNING: Always wear safety goggles and gloves
during installation.
4
67
7
3
7
3
Fig. 2
A
1
VENTING OPTION:
QR015 & QR060 are top venting range hoods.
You must use a top venting system that vents to the outdoors as shown in Fig. 4 and Fig. 5.
Vertical Roof VentingHorizontal Wall Venting
16
14
15
13
Fig. 3Fig. 4
Ensure that you have enough vertical space in the cabinet as to allow for the housing of the motor and any ductwork necessary for your
installation.
7 CONGLOMKB.COM
Please contact 1-877-333-0098 for further assistance.
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.