Page 8
6. Transition and placement
7. Cautions for Safety
*It must be checked that the voltage used should be the same as the rated voltage before
the freezer used.
*The power plug should have its own separated socket in order to prevent the electric
wire from being over heated by other plugs.
*Do not store flammable materials such as alcohol, gasoline, LP gas and glue etc. in the
freezer.
Page 9
8. Trouble shooting
Serial
No.
Problem Reason Resolvent
1
Don't
freezing at
all
power plug is well-connected or not change the plug or socket
power off or not turn on the power after 5 mins
fuse is cut off or not change the fuse
if the thermostat button under lever
"1"
rotate the button
if the socket becomes to flexible make it to be tight
2
Freezer
operating
weak freezing
capacity
if the evaporator cover with thick
frost
turn off it and defrost it
whether open the door Frequently don't open it to frequently
the storage it too much low the storage down
whether any leakage of gas refill the gas
whether the environment temp. is
too high or the control panel turned
to the lowest level
Lower down the environment
temp. Or turn the control
panel to higher level
Freezer
internal
temperature
reach to -25
the thermostat is closed to "5" adjust it to normal level
the thermostat is failure change the thermostat
3
Heavy
noise
if it is lay down and stable adjust the bottom foot
if the cooling-pipes hit each others
when working
adjust the position of pipe
if it is the screw for compressor is
untight
make it to be tight
4 Indicate light is not on , but the freezer properly change the indicate light
5 Power Cord is broken change the power cord