Prem-I-Air TJF120-LD012 Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

When using any electrically powered product, basic safety precautions should always be followed.

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.

1. Check the household voltage to ensure it matches the units rated specification before operating.

2. Close supervision is necessary when the unit is used by or near children or pets, or left unattended.

3. Do not allow children to play with any product packaging, such as plastic bags.

4. Do not operate the unit with a damaged cord or plug, after the product malfunctions, or has been dropped of damaged in any way. Return the complete product to an authorised service facility for examination and repair.

5. This product is intended for domestic use only and not for commercial, industrial or outside use.

6. Always turn the unit off and unplug before moving location.

7. To disconnect from the power supply, grip the plug and pull from the power socket. Never pull by the cord.

8. Do not operate the unit in areas where petrol, paint, or other flammable liquids are used or stored.

9. Do not use the unit in artificially hot or humid conditions or allow it to be used in any hazardous environment.

10. Do not place the unit near an open flame, cooking or heating appliance, or hot surface.

11. This unit is not intended for use in wet or damp locations. Never locate the unit in an area where it may fall into a bath or other water container. Always use on a dry level surface.

12. Do not let the power cord hang over the edge of a table or counter. Arrange the power cord away from an area where it may be tripped over.

13. Never place the power cord under a carpet or rug.

14. Do not place objects on the product or allow objects to obstruct the inlet or outlet openings. Do not operate in close proximity to walls or curtains, etc.

15. The use of attachments or accessories not recommended or sold by the product distributor is not recommended as they may cause injury to persons or property and void the warranty.

16. Do not attempt to repair the unit other than to replace or clean the filters. To repair the unit take it to a qualified service engineer.

17. Set on high speed to clean room air rapidly and then turn to low speed half an hour later. When used at night, set the speed at low to keep the air fresh and clean or OFF for Ionic cleaning only.

18. If the supply cord is damaged it must be replaced by the

Manufacturer or an authorised service centre in order to avoid a hazard.

This product has been manufactured to comply with EEC

Directives 73/23/EEC and 89/336/EEC

BS PLUG WIRING

Wiring Instruction: Should it be necessary to chang e the plug please note the wires in the mains lead are coloured in accordance with the following code:

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

1. The BLUE wire is the NEUTRAL and must be connected to the terminal marked with the letter N or coloured BLACK.

2. The BROWN wire is the LIVE and must be connected to the terminal marked with the letter L or coloured RED.

3. NEITHER WIRE should be connected to the terminal which is marked with the letter E, or coloured GREEN or GREEN /YELLOW.

Always ensure that the cord grip is positioned and fastened correctly. If a 13A ( BS1363 ) fused plug is used it must be fitted with a 3A fuse. If in doubt consult a qualified electrician.

Wiring for a 13 Amp Plug ( BS1363 )

BLUE – NEUTRAL BROWN – LIVE

SERVICE & WARRANTY

For your convenience, record the complete model number and product name (located on the Product Identification Plate), the date you purchased the product, and attach your purchase receipt as proof of purchase. To ensure your product is covered by warranty, the receipt should be returned to your retailer.

complete faulty product together with your purchase

ONE (1) YEAR LIMITED WARRANTY

Save This Warranty Information

EHS (International) Ltd. Guarantees this product free from defects in materials and workmanship for a period o one (1) year.

Should this unit be operated under conditions other than those recommended, at voltages other than the voltage indicated on the unit, or any attempts made to service o modify the unit, will render this WARRANTY VOID. The product you buy may sometimes differ slightly from illustration. This warranty is in addition to, and does not affect, your statutory rights

Should you have a problem with this product, please call our Help Desk on: (0870) 742 5021

Air Purifier

TJF120-LD012

Please read this instruction

manual before operating and keep

safe for future reference.

OPERATION

Fan Switch Low Speed Indicator High Speed Indicator Ioniser Switch and indicator

1. Ensure filter is unpacked and installed before operation. (Refer to Installation Instructions Section).

Best performance:

We recommend that you operate your air cleaner 24 hours a day because indoor air can be quickly contaminated by activity in a room, for example outside air, smoking, and other air pollutants. While the air cleaner will not process all the air in a room, the more air circulated through your air purifier, the more filtered air returned to the room. Portable air cleaners will be much more effective in rooms where all doors and windows are closed. However, for best performance the air outlet slot should be kept clear, at least 1 metre (three feet) in all directions.

2. Insert the main’s plug into a suitable power socket, checking first that the household voltage matches the voltage stated on the product rating plate.

3. Press the FAN button to turn your air cleaner ON. The fan will start at HIGH speed. Press the FAN button again to select LOW speed. To turn the air purifier OFF press the FAN button again.

4. Press the IONISER button to turn on the IONIC purification mode, the IONISER light is now lit. Press the IONISER button again to turn OFF this function. REMEMBER you can use the IONIC purification mode with the fan OFF for silent filtration.

IMPORTANT: if the Collector Plates are not refitted correctly your Air Purifier will not start. If your Air Purifier fails to start check the fitting of the Collector Plates first.

IMPORTANT: your IONIC Air Purifier produces a stream of ION charged air in order to silently filter all the air in your room. If placed too closely to a TV or Radio it may cause some interference. We recommend that your IONIC Air Purifier is placed at least 2 metres from a TV or Radio.

MAIN FEATURES

1. Purification function: This purifier is equipped with an odour filter system, which consists of an activated carbon filter. This Air Purifier uses stainless steel collection plates in conjunction with ION generators to remove airborne pollutants and irritants from the air silently and without filters. The purification system can eliminate smoke and odours, absorb and decompose harmful bacteria in the air, thus reducing air pollution and ION generator draws air into your Air Purifier where it is further attracted to the stainless steel collector plates and the dust and particles are trapped. Clean air is thus pushed out of your air purifier helping to create a circulation of air within your room.

2. Negative ion function: Negative ions are discharged to combine with dust, bacteria and mildew in the air, and remove them.

3. Fan Boost: You can use the fan boost to clear a room when you first start your Ionic air purifier, after a period of non use or to boost odour removal through the activated charcoal filter.

improving air quality in the home. An

PARTS DESCRIPTION

Lift here to remove the Stainless Steel Collector Plates

Stainless Steel Collector Plates Control Panel

Activated Carbon Filter

FILTER INSTALLATION AND MAINTENANCE

Block Filter frame Body

IMPORTANT: Switch off and unplug your Air Purifier before removing the Filter.

Unlock the Filter tray by pushing the lock button up. Using the finger recess, ease the filter tray from the main body. If you usually run your Air Purifier with the fan the filter can become dusty and may be gently cleaned with a vacuum cleaner hose attachment. The Charcoal Filter should be replaced every 9 to 12 months or when you notice that the odour reducing effect has diminished. For replacement filters contact our Help Desk on 0870 742 5021

COLLECTOR PLATE CLEANING

IMPORTANT: Switch off and unplug your Air Purifier before removing the Collector Plates.

Hold the handle on the top of your Air Purifier and pull the assembly upwards. Wipe the stainless steel plates clean with a soft dry cloth or a neutral detergent if necessary. Ensure that the Collector Plates are dry before refitting and using your Air Purifier.

NOTE: If you do not clean the Collector Plates regularly you will notice the occasional noise coming from your Ionic Air Purifier. This is perfectly normal and will stop once the plates have been wiped clean.

MAINTENANCE

CAUTION: SWITCH OFF AND DISCONNECT FROM POWER SUPPLY BEFORE SERVICING

1. To clean the unit use a soft cloth to wipe off any dust. If the unit is very dirty use a damp cloth. Do not use any cleaning detergents, sprays or any other chemicals as these will damage the unit. Ensure no water enters into the machine.

2. Replace the Charcoal Filter when you notice that the Charcoal Filter is no longer removing the smells or after 9 to 12 months.

3. Do not use your unit in areas where there is thick dust or

smoke, as this will damage the filter.