Page 1
EH0209 (JDO110V)
Heavy Duty 110V Halogen Heater
2 Heat settings
Adjustable thermostat
Free-standing or wall mounting
Convenient carrying handle
Safety overload cut-out
Operates from site-safety transformers
Page 1
Page 2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
BEFORE USE
You must inspect the product including its cable and plug for
any signs of damage. If the product is damaged, DO NOT
use it, and contact your supplier immediately.
INSTALLATION
Attach one braked castor and one unbraked castor to each
foot, using the M6 nut and washer provided.
Turn the main body of the heater upside-down and attach the
foot assemblies (complete with castors) to the underside of
the heater, using the M6x45mm screws provided. The braked
castors should both be at the back of the heater.
Return the heater to the upright position.
Attach the handle to the sides of the main body of the heater
using the M6x45mm screws provided, ensuring that the
handle is to the back of the heater.
PRODUCT SAFETY
•
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not
play with the appliance
Page 2
Page 3
•
Place the EH0209 on a firm flat stable surface, and apply
the brakes to both braked castors.
•
Ensure that curtains are at least 900mm (3') from the top of
the heater.
•
Do not cover. This symbol shown on the casing of
the heater means that the heater should not be
covered.
•
For indoor use only
•
Not suitable for use in boats, caravans or similar locations.
•
Do not locate the heater immediately below a mains socket
outlet.
•
Do not use this heater in the immediate surroundings of a
bath, shower or swimming pool.
•
Do not place the mains lead beneath a carpet or rug.
•
Do not use the heater in locations where paint, petrol or
other flammable liquids are used or stored.
•
Do no insert any object into the heater through the grilles.
This may damage the heater or result in overheating or
electric shock.
•
Do not use this heater with a programmer, timer, separate
remote-control, or any other device that switches the heater
on automatically, since a fire risk exists if the heater is
covered or incorrectly positioned.
•
The fireguard of this heater is intended to prevent direct
access to heating elements and must be in place when the
heater is in use. The fireguard does not give full protection for
young children and infirm persons.
•
Do not leave the heater unattended.
•
You must not replace the 32 Amp plug with a 16 Amp plug.
Page 3
Page 4
OPERATION
Plug the mains lead into a 32 Amp 110V socket. (A 110V
scoket will be coloured YELLOW). If operating from a
transformer, ensure that the CONTINUOUS rating of the
transformer is greater than 2000W. (This will require an
intermittent or "power tool" rating of at least 3000W)
If connecting via an extension lead, make sure that the lead
is rated at 32 Amps, and that it is fully unwound.
Place the EH0209 on a firm flat stable surface, and apply the
brakes to both braked castors.
Use the two switches on the side to select the required
operation:
•
One switch on = Low Heat (1000W)
•
Both switches on = High Heat (2000W)
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.11 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill.
At this cost, the EH0209 will cost £0.11 per hour to run on the
"low heat " setting, and £0.22 per hour to run on the "high
heat" setting with the thermostat set to its maximum.
Page 4
Page 5
MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the
mains supply. The heater may then be cleaned using a damp
cloth with a drop of washing-up liquid to remove any dust or
dirt from the case. Do no use stronger detergents or solvents
as these may damage the paint finish.
Using a dry paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre. If the mains
plug needs to be replaced, proceed as follows:
•
Connect the brown wire to the terminal labelled "L" or
"Phase"
•
Connect the blue wire to the terminal labelled "N", or
unlabelled.
•
Connect the green/yellow wire to the terminal labelled with
the earth symbol or "E".
•
Make sure that the cord-grip is positioned correctly (over
the outer sheath of the cable) and it fully tightened.
REPLACING THE TUBE
Disconnect from the mains supply, and wait until the heater
has cooled down.
Using a pozidriv screwdriver, remove the grille.
Push the tube sideways against the spring, and remove.
To insert a new tube, push one end of the tube into the
socket against the spring, and insert the free end into the
opposite socket. Do not touch the glass tube with bear
hands.
Replace the grille.
Replacement tubes can be obtained from your supplier, or by
telephoning (0845) 459 4816 quoting part number EH0603.
Page 5
Page 6
FAULT FINDING
If the overload trip on the transformer operates, check that
the transformer has a CONTINUOUS rating of at least 2000
Watts.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic
household waste.
Most local authorities have specific collection system for
appliances and disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new
appliance your retailer may take the old appliance for
disposal.
TECHNICAL SPECIFICATION
Dimensions: 880x490x550mm
Weight: 15.7kg
Power supply: 110V AC
Power consumption: 2000W
Operating current: 18A
Connector 32A 110V plug
Page 6
Page 7
SERVICE WARRANTY
Prem-i-Air guarantees the product free from defects in
materials and workmanship for a period of twelve months.
Should this unit be operated under conditions other than
those recommended, at voltages other than the voltage
indicated on the unit, or any attempts made to service or
modify the unit, then the warranty will be rendered void.
The product you buy may sometimes differ slightly from
illustrations. This warranty is in addition to, and does not
affect, your statutory rights.
If you have any problems with this product, please call our
Help Desk on (0845) 459 4816.
Prem-i-Air Appliances Ltd.,
Lancots Lane,
Sutton Oak,
St. Helens,
Merseyside.
WA9 3EX
website: www.prem-i-air.com
Page 7
Loading...