Prem-I-Air Isla Gurney, Isla Stockay, Isla Calvay Installation And Operating Instructions Manual
Revision 0
ISLA RANGE OF
FREESTANDING
WOODBURNING
S T O V E S
Installation and Operating
Instructions
Please hand these instructions to the stove user when the
installation is complete. Leave the system ready for operation
and instruct the user in the correct use of the appliance and
operation of controls.
Installation – Must be installed by a qualified plumber or
suitably qualified fitter
Revision 0
Assembly Instructions
PLEASE READ THESE INSTRUCTIONS CAREFULLY
It is important that your stove is correctly installed, as Prem-i-air cannot accept
responsibility for any fault arising through incorrect installation.
Remove the plastic bag and,
upon opening the door, remove
all the contents
Carefully remove the steel straps
and lift off the upper crate
Your Prem-i-air stove comes
packed in a plywood crate
Revision 0
1. Remove stove from pallet and carefully tip it over onto its back.
2. Sort out the legs and fixings.
3. Ensure the tapped holes, on the base, are free from obstruction. Use a sharp
screwdriver to remove any fire cement. Secure the legs and fixings using the screws
and washers provided
Revision 0
1. Fit the Flue Collar using the 4-M6 set screws and washers supplied.
If the Top Flue position is required remove the fitted Flue Cover and refit on the
rear opening.
2. To fit the Baffle:
Insert the baffle, upside down, as shown, ensuring you are holding the shorter of the
two sides. Turn the baffle as you fit it, so that the edge that you are holding is placed
on the ledge at the rear of the stove. The other edge rests on the back plate between
the front and back lips as shown below.
Revision 0
List of Components
Description of Parts
Door Handle 1
Airwash Control Handle 1
Primary Air Caps 2
Riddling Handle 1
Ash Pan 1
Ash Pan Tool 1
Coal Guard 1
Baffle Plate 1
Legs 4
Leg Height Screws M17 4
Leg Screws M14 8
Leg Washers 8
Flue Collar 1
Flue Collar Screws M10 4
Flue Collar Nuts M10 4
Flue Collar Washers 4
Loading...