Prem-I-Air EH0287 Instructions Manual

EH0287

2 kW 9-Fin Oil-Filled Radiator

3 Heat settings
Adjustable thermostat
Built-in carrying handle
Durable Castors
Safety overload cut-out

Page 1

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the
user of the product for future reference.

INSTALLATION

Attaching the feet.
Turn the appliance upside down and place on a flat surface.
Hook the U-shaped brackets between the first and second

fins (from each end).
Push the ends of the U-shaped bracket through the holes in

the castor bracket.
Fix the wing nut to the threads on one end of the U-shaped

bracket, and tighten. The castor bracket should fit neatly
between the two fins.

Attach the castors to the holes in the ends of the castor
brackets using the dome-nuts.

Return the appliance to the upright position. The controls
should be towards the top, and the cable entry towards the
bottom.

Page 2

OPERATION

Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead

is rated at 13 Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
Use the two power control switches on the side to select the

required operation:

•

Both switches off = OFF

•

Left switch ON = Low Heat (650 W)

•

Right switch ON = Medium heat (1350 W)

•

Both switches ON = High Heat (2000 W)

Unplug the appliance from the mains when not in use.

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.
Turn both switches on (high heat), and rotate the

temperature control fully clockwise.
The appliance will then operate at maximum output. When

the desired temperature is reached, rotate the temperature
control anticlockwise until a click is heard. The appliance will
then switch on and off to keep the room at the desired
temperature. The indicator light will show that this is
happening.

Either the low, medium or high heat setting can be used.

Page 3