Page 1
15" SUPER WOOFER
USER MANUAL
WITH BLUETOOTH, USD/SD, FM PLL RADIO, ACTIVE AMPLIFIER,
LED DISPLAY, REMOTE CONTROL AND 3-WAY POWER SOURCE
PA1540B
Page 2
WARNING !
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER THIS
SPEAKER. NO ADJUSTMENTS INSIDE FOR YOU. ALL SERVICES MUST BE SUBMITTED TO
QUALIFIED PARTY.
The symbol represented by a ray with arrowhead within an equilateral triangle is intended
to alert the user to the presence of dangerous voltage within the unit that may be of
sufficient magnitude to constitute a risk of electric shock people magnitude.
Users should take extra care when this symbol appears in this manual and should take
every care described.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important instructions for maintenance (services) and the use of this device in
this manual.
1. Read these instructions.
2. Guard this manual.
3. Obey all alerts.
4. Follow all instructions.
5. : To prevent fire or shock hazard, do not expose this equipment to rain or
moisture. Do not store and operate this product near liquid.
6. only with dry cloth.
7. Not store and not operate this product near any heat sources such as radiators and heat
registers, stove or other appliances (including amplifiers) that produce heat. Keep this
product in a well ventilated place.
8. Not ignore the safety purpose of the polarized or grounding plug. A polarized plug has
two blades being wider than the other. A grounding plug has two blades plus a round
pin to ground. The wide blade or the third prong is intended to provide security. If the
provided plug does not fit into your outlet, consult an electrician to replace the outlet.
9. Protect all wires connected to this unit from being walked on or pinched, particularly at
plugs and the point where the cord exits the unit. When unplugging from the electrical
outlet, grasp the plug and do not pull the cord.
10. Disconnect the unit during lightning storms or when long period is to remain unused.
11. Keep this unit off when connecting all the devices connected to it.
12. After finishing the installation and connections, connect all your equipment with low
volume level. Once all devices are connected, slowly increase the volume or level
controls to achieve the proper position.
13. placement, installation, assembly or suspending any product, inspect all
equipment, suspension, cabinets, transducers, brackets and associated equipment.
Any missing component, corroded, deformed, or with non-nominal load can reduce the
intensity, placement and arrangement of the installation significantly. Any of these
conditions can reduce the security of the facility and must be corrected immediately.
Use only suitable equipment for the loading conditions of the installation and that any
possibility of reducing term, unexpected overload, never exceed the capacity of the
material or equipment.
14. Consult a licensed professional to install the equipment and make sure that all local,
regional and national regulations related to security are understood and adhered to.
15. services should be performed by qualified professionals. Servicing is required when
the apparatus has been damaged in any way, as if having the power cord or its damaged
connector, or if the machine breaks contact with liquid or if any object is inserted in the
unit or if the unit is exposed to rain or moisture, or if the unit does not operate normally,
or has been dropped.
BE SURE TO FULLY CHARGE THE BATTERY FOR THE FIRST TIME TO INCREASE BATTERY
DURABILITY.
WARNING
Clean
Before
All
1
Page 3
2
REAR PANEL
- +
MIC
INPU T
DC 12 V IN
AC
DC
POWE R
AUX
INPU T
AC 100 -240V ~50/6 0Hz
ANTE NNA
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
FULL
BATT
Page 4
3
1.
2. Master Level Volume Control: Turn this knob to adjust the master volume.
AUX Input (RCA): The RCA Input is designed to connect directly to a
CD/DVD/TV or any other stereo level audio device.
Please note that there are two LINE(AUX) Inputs, RCA and 1/8”. If both the RCA
and 1/8”inputs are connected the unit is automatically play from the 1/8” Line input.
Previous Track Button: When on USB/SD/Bluetooth mode, press this button
to move to the previous track. Hold it down to reduce the volume.
When on FM mode, press this button to move to the previous stored channel.
12. Input Mode Button: Press this button to toggle between the various inputs
(LINE, USB, SD ,FM & Bluetooth).
13.
is button to pause or play. Hold it down to select the repeat modes
for USB/SD.
When on Bluetooth mode, press this button to pause, hold it down to disconnect
pairin
When on FM mode, press this button to mute, hold it down for auto scan.
14. Next Track Button: When on USB/SD/Bluetooth mode, press this button to move to
the next track. Hold it down to increase the volume.
When on FM mode, press this button to move to the next stored channel.
15. USB/SD card port: Connect your USB or SD device here. The speaker will only play
music files from USB/SD input. Do not connect your computer to this input as it will
not play files directly from a computer.
Noted: This unit will keep repeating all songs in USB and SD in default.
Important: The USB port is intended only for data transfer only, other devices cannot
be used with this USB connection. The use of USB extension cords is not
recommended.
When the unit is fully charged, the LED will lights up solid in green.
3. Power & Bluetooth Indicator: The power indicator will light up solid when
when pairing.
4. Treble adjustment: Turn this knob to increase the treble.
5. Bass adjustment: Turn this knob to increase the bass.
6. Microphone Echo Knob: Use this knob to adjust the echo for the
microphone input.
7. Microphone Volume Knob: Turn this knob to adjust the microphone volume
level of the microphone input.
8. Guitar Volume Knob: Turn this knob to adjust the volume level of your guitar.
9.
the unit is ON or under charging when unit was set off. Bluetooth indicator will
light up solid when connected flash
slowly in BT playback, and it flashes quickly
or
10.IR remote receiver.
11.
Pair & Repeat Button&Play/pause Button: When on the mode of USB/SD,
press th
g then enter pairing mode.
Page 5
4
REMOTE CONTROL
3
5
6
10
11
7
1. POWER: Press this button to ON/OFF
the unit. Four dots (- - - -) is displayed when
standby.
2. INPUT:Press this button to toggle between the
various inputs for LINE(AUX), USB/SD, FM ,
Bluetooth.
3. KEY Number for selecting the certain track for
USB/SD or stored channel in FM.
4. MUTE: Press this button to mute
5. VOL+: Press this button to increase the volume.
6. VOL-: Press this button to reduce the volume.
7. CH-/ : Press this button to select the previous
track or stored channel for USB/SD/Bluetooth/
FM.
When on USB/SD mode, hold this button to fast
backward .
8. CH+/ : Press this button to select the next
track or stored channel for USB/SD/Bluetooth/
FM.
When on USB/SD mode, hold this button fast
to forward.
stand by
16. Power button: There are three possible settings. Setting the unit to DC (BATT) will
allow the unit to play using only internal battery.
When set to AC, the unit can also be powered by an external power supply
(electrical outlet) even if the battery is dead.
*In AC setting the unit will still under charging, but it will do very slowly. To charge
the unit properly, set the unit to OFF.
17.DC 12V IN is for connecting to 12V external battery if needed. Make sure positive
to positive (red +) negative to negative (black -).
18.
Microphone Input(1/4"): Connect a microphone to this microphone input
terminal.
21.AC Connection: Connect the power cord to AC outlet.
22.Antenna is for receiving the FM signal. Before used, extend the telescopic
FM antenna. Pack up the FM antenna to better protect it after used.
AUX(1/8"): The Input is designed to connect directly to a Mp3 Player or any
other stereo level audio device.
19.Guitar Input(1/4"): Connect a guitar to this guitar input terminal.
20.
Page 6
5
9. EQ: Press this button to select the different EQ mode for USB/SD.
10.PREVIOUS/NEXT Folder Button: Press this button to move to the previous/next
folder on USB/SD drive.
11. SCAN, PAIR, REPEAT & PLAY/PAUSE button: Press this button to play or pause
the track of USB/SD/Bluetooth/FM. When on Bluetooth mode, hold it will
disconnect the pairing. Hold it to auto scan in FM. Hold it to select the repeat
modes for USB/SD. Which is equivalent to the play/pause key (13) on the main
unit’s rear panel.
MICROPHONE
Microphone
ON/OFF
1.
2.
Before powering on the microphone, be sure to set
the Microphone Volume Knob to zero. Once the
microphone is powered on, slowly increase the
microphone volume.
If you notice static or distortion in the microphone,
check the Mic connection.
3. When not in use, turn off the power of the
microphone.
Page 7
DIGITAL DISPLAY
6
INPUT MODES: The LED display screen will display the information of input
modes for USB/SD/LINE(AUX)/FM/Bluetooth.
1. When a USB flash drive/SD card is inserted into the USB/SD input, the unit will
automatically switch to USB/SD mode and the display shows USb or Sd.
EQ Mode: EQ modes will display here,
2. Track Number: The track number currently playing from the USB/SD will display.
Pop, Rock, Jazz, Classic, Normal for
USB/SD.
Repeat Mode: When the USB flash or SD card mode is selected, press the RPT
button (hold play key) to select Repeat Play for repeat folder/
one/ random/ ALL.
3.
4. Bluetooth Mode:
FM Mode: All FM channels display here. Hold “PLAY/PUASE” button for scanning
all channels.
To disconnect pairing, Hold the “PLAY/PAUSE” button.
Light effect auto on when this unit is turned on.
USb
Sd
bLUE
Page 8
BATTERY
1. The unit is a battery powered PA loudspeaker. Be sure that you have
completely charged the battery prior to first use to maximize the battery's
lifespan. The unit takes approximately 2 hours to fully charge. The unit will
automatically begin charging once the power cord is connected to a power
source and Power Switch is better set to off.
The unit will also power on when connected to a AC power source even if the
battery power is low.
When connected to a power source, the unit will play while also charging the
battery slowly.
2. Upon completion of the charging, Please disconnect the power cable.
3. With standard usage, a fully charged battery can play for about 2.5 hours.
4. Battery can be recharged about 300 times in its life time.
5. When not in use, the speaker should always be set fo OFF to prevent the
unit from draining the battery.
6. When the unit is not used for prolonged periods of time, the battery will
gradually lose its power. It is recommended to fully charge the battery
regularly.
7
PAIRING A BLUETOOTH DEVICE
1. Turn on you Bluetooth device.
2. Turn on the speaker to Bluetooth. the unit will automatically go into pairing
mode to search for Bluetooth device. You will know you are in pairing mode
when the LED is flash quickly.
3. If your Bluetooth device is not able to pair to the unit, disconnect the unit's
previous Bluetooth connections and reset the Bluetooth module by holding
play key.
4. Navigate to your Bluetooth device's setup screen, find "PA1540B" and
connect.
5. Bluetooth indicator light will light up solid when connected.
6. To disconnect pairing, .
Note: You can connect with a smart phones or tablet PC with Bluetooth.
hold PLAY/PAUSE button
Page 9
8
CONTROL REMOTO
SPECIFICATION
ACCESSORIES
Speaker Box (Unit)........................... .................1
Remote Control (UM4 Battery x2pcs).................1
Wired Microphone............................................
Warranty Card..................................................
DC Cord............................................................
Instruction Manual............................................
AC Cord............................................................
3.5mm to 3.5mm AUX-IN Cable ......................
RCA to RCA AUX-IN Cable.................................1
GENERAL
POWER REQUIREMENT: AC100-240V~50/60Hz
REMOTE CONTROL: DC 3V 1.5V UM4/AAAX2PCS
POWER CONSUMPTION: AC 30W
FM FREQUENCY: 87.5-108MHz
GROSS WEIGHT: 14.6KG
DIMENSIONS: 49.0cm(L) x40.0cm(W) x 75.0cm(H)
AUDIO SECTION
Output Power..................................... 30W (RMS)
..1
..1
..1
..1
..1
..1
Note: Specifications are subject to change for continuous
improvement without prior notice.
Page 10
The apparatus shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as waves, shall be placed on the apparatus.
Minimum distances 30 cm around the apparatus for sufficient ventilation.
The ventilation should not be impeded by covering the ventilation. Opening with
items, such as newspapers, table-cloths,curtains,etc.
No naked flame sources, such as lighted candles, should be placed on the
apparatus.
When the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
To be completely disconnected the power input, the mains plug of apparatus shall
be disconnected from the mains completely.
The main plug of apparatus should not be obstructed or should be easily accessed
during intended use.
The use of apparatus in moderate climates.
Attention should be drawn to the environmental aspects of battery disposal.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
About Battery pack:
This unit works on the direct AC or supplied battery pack(Model no: LC18650),DC
11.1V,1.8Ah; unplug the AC Power cord from the AC socket to work on the battery
pack(after fully charged);plugging the AC Power cord while the battery pack is
attached in initiates the charging of this battery. When the battery is fully charged
the indicator will turn to green. This playing time may vary with the surrounding
environment, the volume level of the speaker and the battery condition. It is advised
that you wait 10-20 minutes before recharging the battery pack if it has turned flat
or any distortion during operation.
.
.
.
.
.
.
.
.
.
CAUTION:
9
Loading...