A. IMPORTANT SAFETY INSTRUCTIONS
1. Do not operate the unit with a damaged cord or plug, after it malfunctions
or has been dropped or damaged in any way. Return to an authorized
service facility for examination and repair.
2. This unit should always be kept in an upright position to avoid any damage.
3. Locate the unit on a flat stable surface.
4. Check the household voltage to ensure it matches the units rated
specification before operating.
5. Operate this unit in an ambient temperature between 1ºC and 40ºC.
6. Ensure that the air inlets and outlets are not blocked or covered.
7. Do not place the unit too close to curtains or other objects – min 40cm.
8. Do not place in direct sunlight.
9. Never place anything on top of the unit and do not cover with any kind of
material while in use.
10. This product is intended for domestic and light office use ONLY and not for
commercial, industrial or outdoor use.
11. To protect against electrical shocks, do not immerse unit, plug or cord in
water, or spray with liquids.
12. Never unplug the appliance without pressing the "ON/OFF" key first.
13. Always unplug the unit when not in use or moving location. To disconnect
from the power supply, grip the plug and pull from the power socket. Never
pull by the cord.
14. Always empty the water tank before storing the unit away.
15. Close supervision is necessary when any appliance is used by or near
children and pets.
16. Do not run power cord under carpeting, or cover with rugs or runners.
17. Arrange the cord away from areas where it may be tripped over.
18. Never operate or store the unit in direct sunlight.
19. To repair the unit, take to a qualified service engineer. Repairs carried out
by unqualified people may cause damage to the unit or injury to persons or
property and void the warranty.
20. Where possible, avoid the use of an extension cable as they may overheat
and cause a risk of fire. Only use an extension cord after ensuring it is in
perfect condition.
21. Do not use the unit without the air filter.
SAVE AND READ THESE IMPORTANT SAFETY
INSTRUCTIONS
B. BS PLUG WIRING
Wiring Instructions: Should it be necessary to change the plug please
note the wires in the mains lead are coloured in accordance with the
following code:
BLUE - NEUTRAL
BROWN - LIVE
GREEN AND YELLOW - EARTH
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
1. The BLUE wire is the NEUTRAL and must be connected to the terminal,
which is marked with the letter N or coloured BLACK.
2. The BROWN wire is the LIVE and must be connected to the terminal,
which is marked with the letter L or coloured RED.
3. The GREEN/YELLOW is the EARTH and must be connected to the
terminal which is marked with the letter E or or coloured GREEN OR
GREEN/YELLOW.
4. Always ensure that the cord grip is positioned and fastened correctly.
If a 13A (BS 1363) fused plug is used it must be fitted with a 13A fuse. If in
doubt consult a qualified electrician.
Wiring for a 13 Amp Plug (BS1363)
Please note. The Earth Terminal is marked with the letter E or Earth Symbol