Pream-I-Air EH1230 User Manual
User Guide EH1230
EH1230
8500BTU/h Class A
Portable Air Conditioner
•
2 cooling and 2 fan speed settings
•
24-hour timer
•
Built-in Dehumidification function
•
Adjustable louvre
•
Easy to install - no external unit required.
Page 1
User Guide EH1230
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
INSTALLATION.
Install the EH1230 on floor
approximately 36cm (14")
from a wall. Ensure that the
air inlets (on the sides) and
the air outlets (on the top)
cannot be covered.
Expand a small section of the exhaust tube, and screw it
clockwise into the it the
end of the exhaust port
of the unit. Place the
other end of the
exhaust tube into the
adaptor and through the
nearest open window.
Keep the length of the
exhaust tube to a
minimum. Use the
Page 2
User Guide EH1230
foam strip provided to block the rest of the window opening.
This is essential for efficient cooling.
The correct installation of the exhaust tube is shown below:
If the exhaust tube needs bending, do not bend too sharply,
or more than is required.
Do not vent the exhuast tube into a ceiling void. The exhaust
air may be very humid and can damage ceiling tiles.
Connect the air conditioner to the nearest 13A mains socket
using the built-in cable. Do not connect using an extension
lead, unless the extension lead is rated at least 6 Amps, and
is fully unwound.
Do not install the air conditioner in a damp environment (such
as a laundry room). The air conditioner is for indoor use only.
Do not install in direct sunlight (to avoid discolouration of the
Page 3
User Guide EH1230
case).
Do not install close to a source of heat.
The EH1230 is not suitable if the ambient temperature is
below 18°C or above 35°C.
Installing the carbon filter:
1. Remove the filter frame from the unit.
2. Remove the carbon filter from its plastic bag
3. Insert the carbon filter into the back of the unit.
4. Re-fit the filter frame.
Page 4
Loading...