PRAISE PERFECTION 6961442 User Manual

E-1

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE
FIRE OR SHOCK
MOISTURE.

The Rating plate is located at the bottom enclosure of the apparatus

FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT

HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including ampl

9. AC adaptor is used as disconnect device and it should remain readily operable
during intended use. In order to disconnect the apparatus from the mains
completely, the AC adaptor should be disconnected form the mains socket outlet
completely.

10. Only use attachments/accessories specified by the manufacturer.

11. Use only with a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold with the product.
When a cart is used, use c
combination to avoid injury from tip-over.

12. Unplug this apparatus during lightning storms or when unused for
a long period of time.

13. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain
been dropped.

14. This appliance shall not be exposed to dripping or splashing water and that no
object filled with liquids such as vases shall be placed on the apparatus.

15. Do not overload wall outlet. Use only power source as indicated.

ifiers) that product heat.

aution when moving the cart/apparatus

or moisture, does not operate normally, or has

E-2

16. Use replacement part as specified by the manufacturer.

17. Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks.

18. Power Sources - This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of the type of power
supply to your home, consult your product dealer or local power company. For
products intended to operate from batte
operating instruction.

19. Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short-out parts that could
result in a fire or electric shock. Never spill liquid of any kind on the product.

20. Damage Requiring Service - Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the follow
a) When the power-supply cord or plug is damaged,
b) If liquid has been spilled, or objects have fallen into the product,
c) If the product has been exposed to rain or water,
d) If the product does not operate normally by following the operating instructions.

Adjust only those controls that are covered by the operating instructions as an
improper adjustment of other controls may result in damage and will often
require extensive work

normal operation.
e) If the product has been dropped or damaged in any way, and
f) When the product exhibits a distinct change in performance - this indicates a

need for service.

21. The battery shall not be exposed to excessive heat such as sunshine, fire or the
like.

22. Minimum distances of 4 inches around the apparatus for sufficient ventilation.

23. The ventilation should not be impeded by
items, such as newspapers, tablecloths, curtains, etc.

24. No open flame sources, such as lit candles, should be placed on the product.

25. The use of apparatus in moderate climates.

26. Attention should be drawn to the environmental aspects of battery disposal

by a qualified technician to restore the product to its

ry power, or other sources, refer to the

ing conditions:

covering the ventilation openings with

SAVE THESE INSTRUCTIONS

E-3

COMPLIANCE WITH FCC REGULATIONS

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may

cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed t
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interferenc
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or a

CAUTION:

for compliance could void the user’s authority to operate the equipment.

The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. The equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.

This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving
when you operate the controls. These ‘feet’ are made from non-migrating rubber
material specially formulated to avoid leaving any marks or stains on your furniture.
However certain types of oil-based furniture polishes, wood preservatives, or cleaning
sprays may cause the rubber ‘feet’ to soften and leave marks or a ru
the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase
small self-adhesive felt pads, available at hardware stores and home improvement
centers everywhere, and apply these pads to the bottom of the rubber ‘feet’ before you
place the product on fine wooden furniture.

Changes or modifications not expressly approved by the party responsible

FCC ID: 2ASQA6961442

o provide

e to radio or

n experienced radio/TV technician for help.

PROTECT YOUR FURNITURE!!

bber residue on

E-4

DEAR STUDEBAKER

Selecting fine audio equipment such as the unit you've just purchased is only the start
of your musical enjoyment. Now it's time to consider how you can maximize the fun
and excitement your equipment offers. This manufacturer and the Electronic Industries
Association's Consumer Electronics Group want you to get the most out of your
equipment by playing it at a safe level. One that lets the sound come through loud and

ar without annoying blaring or distortion and, most importantly, without affecting

cle
your sensitive hearing.
Sound can be deceiving. Over time your hearing "comfort level" adapts to higher
volumes of sound. So what sounds "normal" can actually be loud and harmful to your
hearing. Guard against this by setting your equipment at a safe level BEFORE your
hearing adapts.

To establish a safe level:

•

Start your volume control at a low setting.

•

Slowly increase the sound until you can hear it comfortably and clearly, and without

distortion.

Once you have established a comfortable sound level:

Set the dial and leave it there.

•
Taking a minute to do this now will help to prevent hearing damage or loss in the
future. After all, we want you listening for a lifetime.

We Want You Listening for a Lifetime

Used wisely, your new sound equipment will provide a
lifetime of
from loud noise is often undetectable until it is too late,
this manufacturer and the Electronic Industries
Association's Consumer Electronics Group recommend
you avoid prolonged exposure to excessive noise.

Customer's Record:

The serial number of this product is found on its bottom. You should note the serial
number of this unit in the space provided as a permanent record of your purchase t
aid in identification in the event of theft of loss.

fun and enjoyment. Since hearing damage

CUSTOMER

o

Model Number: SB3500 Serial Number: