Practecol EOAREM 002 C User Manual

Remote Control

Outlet Adapter

Stops the wasted electricity that devices

Sustainable Solutions

I N S T R U C T I O N S

1. Plug the Remote Control Outlet Adapter into an indoor,
grounded wall outlet.

2. Plug an electrical device into the Remote Control Outlet
Adapter.

3. Press the remote control to power ON your device as indicated
by GREEN LED light on the right side of the remote control.

4. When finished using the device plugged into the Remote
Control Outlet Adapter, turn the device OFF as usual.

5. Then press the switch on the remote control to cut OFF
standby power to the device.

6. When you want to use the device again, FIRST use the remote
control to activate power into Remote Control Outlet Adapter.

7. Then turn ON the device you wish to use.

8. REPEAT steps 4 & 5 as necessary.

REMINDER:

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

generate even when not in use

Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer­ence in a residential installation.

This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

save

sustain

EOAREM-002

125V~60HZ-10A

TUNGSTON LOAD..240W

www.practecol.com

&

simply

™

PMS 376c