Powertech Co PT 462 Users manual

Outdoor Motion-Sensing User’s Manual
Introduction
Using Your Outdoor Motion-Sensing is a convenient way to detect some body is
walking across. The Outdoor Motion-Sensing Light adapter will turns lights on when
motion is detected, and the transmitter will active and send on signal only 1.5 sec. The
light will stay on for 1 or 10 minutes after all motion has stopped and the transmitter
will active and send off signal only 1.5 sec.
Screw the Socket Adapter into the empty light socket and then screw light bulb into
Socket Adapter.
Battery Installation
1. Remove battery cover from the bottom of the sensor housing by pushing open the
sliding battery door.
2. Install one 9-Vlot alkaline battery into the battery compartment. Be sure the
battery(+)and(-)terminals match (+)and(-) contacts on battery cap.
3. Replace battery cover.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY
RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
Loading...