PowerTec P-LM13 User Manual

P-LM13 Powertec Lat Machine

The Lat Machine comes in two cartons. Box 1 is 205cm x 19cm x 17cm and weighs 26kgs. Box 2 is 110cm x 58cm x
27cm and weighs 47kgs.

Put the footplate on the base section first. I used the box to rest the base on while I screwed in the bolts. I tightened
these with the allen key provided.

Now I thought it would be a good idea to unwind the base cable from the base section. I then used some of the
protective bubble wrap from some of the parts and placed the cable inside. I didn’t want to leave it lying on the
ground where I may accidentally step on it.

The rear support needs attaching to the base section. Don’t forget the backing plate!

Now time for the chrome guide tubes. The threaded section is up the top. The end with holes is at the bottom. Once
you put the tubes in place, put the 3/8’’ bolts through and secure with the nuts. Just do them finger tight.

You then slide the long support tubes down the guide rails. Don’t forget to rubber bumpers on too. They should be
at the top. They will protect the bottom nylon bushes on the weight carriage.

Before we can install the uprights for the knee pads, we need to take the pulley at the rear of the base off so we can feed the
cable back through. DON’T JUST PLONK THE UPRIGHT ON TOP OF THE CABLE!