a. Dual mode support for both AirFuel MR and WPC Qi
enabled devices
b. For evaluation purposes and best performance, place
PRUs inside the effective charge area. Production
design charge area is significantly larger
3.
Charging Qi Enabled Devices
a. Place up to three Qi enabled devices at once
I. Place on any of the three Qi alignment marks
b. Smart device will light up when alignment is complete
c. SkyCurrent™ 30 can charge any Qi-enabled device
4.
2.
Connect Power Cord to SkyCurrent™ 30
a. Connect the power cord to the SkyCurrent™ 30
charging pad
b. Plug the opposite end of the power cord into an
AC (mains) power outlet
c. Blue light indicates SkyCurrent™ 30 charging pad
is on
Charging MR Enabled Devices
a. Place up to four AirFuel MR-enabled devices at
once
b. Can place MR-enabled devices anywhere on pad
c. Charges different devices with various power
requirements
Providing wireless power solutions to build a Connected World, Unplugged™
Your Global Source for RF, Wireless, IoT & Power Technologies
a) If SkyCurrent™ 30 charging pad does not light does not turn on, unplug adapter from wall, wait 10 seconds and
plug back into AC (mains) power outlet
b) If Qi-enable smart devices do not charge align them to designated Qi-alignment marks on SkyCurrent™ 30
charging pad
c) If SkyCurrent™ AirFuel MR enabled devices do not charge, pull off SkyCurrent™ 30 charging pad and then
replace on charging pad
d) If headphones (PRU) does not charge, make sure that the earpiece with the PowerSphyr sticker is showing, and
the earpiece with the logo only (lightning bolt) is face down on the SkyCurrent™ charging pad
e) If LED light does not illuminate, pull off the pad, and replace on pad
f) If speaker does not produce sound, make sure it is paired with your Bluetooth™ device and then place back on
the charging pad
g) If the transmitter gets warm, please ensure the PRUs are inside the effective charge area. This is approximately
1 cm or .5” inside the gray charge surface. Please note: production transmitters effective charge area is the
entire gray charging pad.
h) Because the PRUs are demonstrator prototypes and do not contain a battery, they will continue to charge
indefinitely and may get a little warm during extensive use. This normal. Simply give the PRU a break now and
then and place again later.
Specifications:
• Compatibility: Any Qi, AirFuel or PowerSphyr
enabled receiving device
Approximate Dimensions:
• Length: 273mm
• Width: 149mm
• Height: 25mm
Approximate Weight:
• Unit and charging cable: 3lb
• Shipment: 4.2lb
Specifications:
• Charge your own Qi enabled device or one of three
provided AirFuel enabled devices
• Reference design for dual-mode phone sleeve
Compatible with iPhone 7 & 8; and Samsung Galaxy S9
Multiple Wireless Charging Proof Points:
• LED light bulb
• Bluetooth™ Enabled Personal Headphones
• Bluetooth™ Enabled Speaker
• Apple and Samsung Qi-enabled smart phones
• Any Qi-enabled consumer electronic
Providing wireless power solutions to build a Connected World, Unplugged™
Your Global Source for RF, Wireless, IoT & Power Technologies
These evaluation kits, including charging pads and consumer devices, have been built and
modified by PowerSphyr, Inc. These evaluation kits are prototype units. Not for resale and
not FCC Certified.
Providing wireless power solutions to build a Connected World, Unplugged™
Your Global Source for RF, Wireless, IoT & Power Technologies