Power-Sonic FC SerieS User Manual

Battery Chargers

For Sealed or Valve Regulated

Lead Acid Batteries

FC-Series

OPERATING PROCEDURES AND SAFETY INSTRUCTIONS

CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER NO USER FRIENDLY PARTS

CAUTION
THIS UNIT SHOULD NOT BE USED IN OUTDOOR APPLICATIONS.
EXPOSURE TO MOISTURE MAY RESULT IN FIRE OR SHOCK HAZARD

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS— This document contains important safety and operating instructions for all FC­Series battery chargers. Before using the battery charger please read all instructions and
cautionary markings on the battery charger, the battery and the product using the battery.

CAUTION!

To reduce the risk of electric shock:

Do not expose the unit to rain or moisture—use indoors only.
Do not remove cover. There are no user serviceable parts inside. Refer service to qualified service person­nel.
The plug must be plugged into an outlet that has been properly installed and grounded in accordance with
all local and national codes and ordinances.
Disconnect charger from AC power before attempting any maintenance or cleaning. Turning off controls
may not reduce this risk.

WARNING!

Do not attempt to recharge non-rechargeable batteries. Charge only sealed or valve regulated , lead- acid,
non-automotive, maintenance free rechargeable batteries. Attempting to charge other types of batteries
may result in personal injury and battery damage.

The enclosure will become hot during the charging cycle—DO NOT TOUCH!

Connect or disconnect the output connectors only when the unit is disconnected from AC power or arcing
and burning may result (due to the possible presence of explosive gases).

Ensure correct polarity connection: positive (red) to positive, negative (black) to negative.

Do not leave chargers plugged in when they are not connected to a battery.

DANGER!

Never make alterations to the charging unit provided. If it will not fit the outlet have a proper outlet in­stalled by a qualified electrician. Improper connection will result in the risk of an electric shock or fire.

Make sure any cords are located so that they will not be stepped on, tripped over, or otherwise subjected
to damage or stress. Do not operate this unit with a damaged cord or plug – replace the complete unit im­mediately. To reduce the risk of damage to electric plug, pull by plug rather than cord when disconnecting
unit.

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way.
Do not disassemble charger; incorrect reassembly will result in the risk of an electric shock or fire. Refer
service to qualified service personnel.

Recharge batteries in well ventilated areas to prevent build-up of explosive gases. Allow space around the
charger and adequate air circulation to reduce internal heat buildup.