Powersmart DB7103, DB7103PA Quick Setup Manual
Quick Set-up Guide Model: DB7103/DB7103PA
Step 1. Remove snow thrower from carton and
place control panel behind it.
Step 2. Install the lower and upper handlebars.
1. Remove the 4 bolts and washers attached to the rear of the frame and install lower
handle bars there.
2. Attach upper and lower handle bars using the set of 4 curved bolts, washers, and
knobs. Tighten firmly.
NOTICE: Do not bend or kink the control cables. The cables should be routed under the
handle assembly and not wrapped around the handle or knobs. The cables must move
freely and not bind.
Step 3. Installing the chute.
1. Remove the bolts and nuts from the bracket at the base of the chute.
2. Position the chute arm next to the brack et an d use the bolts to secure it.
3. Replace the nuts inside the bracket and tighten firmly.
Step 4. Installing the chute handle.
1. Attach holder to the left side of upper handle bars by removing a washer and nut
from the end, inserting into the hole, then reattaching.
2. 1. Remove the screw from the end of the handle then insert into the sleeve. Insert
screw and tighten.
Step 5. Install the skid shoes.
1. Raise auger housing so that the shave plate is
just above the ground.
2. Attach skid shoes.
Step 6. Add oil and gasoline
1. Add 5W30 O il up to the range level on the dip stick (approximately half a quart)
2. Fill gas tank with fresh 87 octane or higher unleaded gasoline.
Tips - You can find a video of the set up instructions on our website.
Powersmartusa.com
Amerisuninc.com
©2016 Amerisun Inc., Itasca IL
Loading...