Powerplus POWLI113 User Manual
PORTABLE ENERGY SAVING WORK LIGHT
Read the manual before using the machine
In accordance with essential applicable safety standards of European
directives
POWLI113 EN
POWLI113
1 DOMAIN OF USAGE
Outdoor or indoor usage such as jobsite, garden, studio and workshop.
WARNING! Read this manual and general safety instructions
carefully before using the appliance, for your own safety. Your
power tool should only be passed on together with these
instructions.
2 SYMBOLS
In this manual and/or on the machine the following symbols are used:
3 WARNING
Switch off lamp before plugging into the socket.
Never attempt to change plug or any inside electronic parts. All electronic parts
should be replaced by a professional electrician.
When tube burns out: Replace ONLY with same specification 2H Fluorescent
bulb(B).
Never attempt to change wire connection way as this has been fixed professionally.
Disconnect the plug (all-poles) from the network when the front PC-cover is open,
and follow the instructions to next step.
Replace PC-cover immediately before using if it is cracked.
If the external flexible cable of this item is damaged, it should be replaced by a
professional electrician.
4 ASSEMBLING LAMP ONTO THE STAND
First unscrew the black wing-nut (C).
Slide the G-shaped tubular base ( D) into black metal clamp at base of the lamp.
Assemble with the wing-nut through the slot in the black metal clamp.
By loosening the wing-nut (C), you can tilt the lamp into the desired angle.
Lock the lamp in place by tightening the wing-nut.
5 HOW TO USE THIS LIGHT
Simply plug in the cable plug (E) into the socket and enjoy bright and efficient lighting.
Do not use the light on a slant ground avoiding falling down and damaging the lamp.
Copyright © 2010 VARO P a g e | 1 www.varo.com
Always keep the lamp away from any heating equipment or similar objects.
Type
POWLI113
Power
2x27W
Voltage/frequency
230 V~50Hz
Bulb type
2H Energy saving bulb 27W
Bulb holder
G410Q-1
Bulb life-span
≥8000 hours
Cable
1.5 m, H05RN-F2GX1.0mm2, with IP44 type plug
Waterproof protection grade
IP44
6 ASSEMBLING A TUBE INTO THE LAMP HOUSING
First unscrew the back screws, (total 6 screws) (A)
Take away the transparent front PC-cover and take out the 2H tube base. Twist and
take out gently the tube from the base. Then take a new 2H tube and gently put in
the lamp into lamp base. Make sure that all metal pins are placed in the hole
correctly.
After replacing, put back the PC-cover and screw all screws back in.
POWLI113 EN
7 SPECIFICATION
8 ENVIRONMENT
Copyright © 2010 VARO P a g e | 2 www.varo.com
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an
environmentally safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist.
Check with your Local Authority or retailer for recycling advice.
Loading...