Powerplus POWLI013 User Manual
PORTABLE HALOGEN FLOODLIGHT 150W
Read the manual before using the machine
In accordance with essential applicable safety standards of European
directives
POWLI013 EN
POWLI013
1 DOMAIN OF USAGE
Outdoor or indoor usage such as jobsite, garden, studio and workshop.
WARNING! Read this manual and general safety instructions
carefully before using the appliance, for your own safety. Your
power tool should only be passed on together with these
instructions.
2 SYMBOLS
In this manual and/or on the machine the following symbols are used:
3 WARNING
Never attempt to change wire connection way as this has been fixed professionally.
The lighting fixture shall be fixed on stand vertically that the longitudinal axis does not
slant than ±4°from the ground plate.
Disconnect the plug (all-poles) from the network when the front glass is open, and
follow the instructions to the next step
Do not put the lamp any closer than 0.8 m to any object.
Replace before using the shielding glass if it is damaged.
If the external flexible cable or cord of this luminary is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
4 ASSEMBLYING LAMP ONTO THE STAND
First unscrew the black wing-nut (C).
Slide the G-shaped tubular base (D) into black metal clamp at base of the lamp.
Assemble with the wing-nut through the slot in the black metal clamp.
By loosening the wing-nut (C), you can tilt the lamp into the desired angle.
Lock the lamp in place by tightening the wing-nut.
Copyright © 2014 VARO P a g e | 1 www.varo.com
5 USING THE FLOODLIGHT
Type
POWLI013
Power
150W
Voltage/frequency
220-240V~50Hz
Bulb type
Tungsten halogen tube
Bulb holder
R7s
Bulb life-span
1000hours
Floodlight facade material
tempered glass
Waterproof protection grade
IP44
POWLI013 EN
Simply plug in the cable (E) of the floodlight to the socket.
6 FIXING AND CHANGING A HALOGEN TUBE
Switch off lamp before installing the bulb.
Remove screw (A) on top of the lamp and open the cover.
Push the bulb (B) in between the two prongs. Make sure the prongs are centered on
the metal tips of the bulb, not the ceramic casing.
To avoid premature burn out of the halogen bulb, It is essential to avoid contact with
bare fingers. If need, please clean the bulb with methylated spirits.
Close cover gently and replace the screw. Never screw cover screw over tight.
7 SPECIFICATION
8 ENVIRONMENT
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an
environmentally safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist.
Check with your Local Authority or retailer for recycling advice.
Copyright © 2014 VARO P a g e | 2 www.varo.com
Loading...