Power Play NG1011T Assembly Instruction Manual
POWER PLAY 40'' AIR HOCKEY
TABLE ASSEMBLY INSTRUCTIONS
NG1011T
THANK YOU!
Thank you for purchasing this product.
We work around the clock and around the globe to ensure that our products
maintain the highest possible quality. However, in the rare instance that your
product is defective or missing parts, contact your retailer, or call 800-759-0977,
to submit parts requests or warranty claims. Please read the warranty
information at the back of these assembly instructions for further details.
IMPORTANT! PLEASE READ THESE ASSEMBLY INSTRUCTIONS
IN ENTIRETY BEFORE ASSEMBLING YOUR PRODUCT.
2
POWER PLAY 40''AIR HOCKEY TABLE - NG1011T
HARDWARE PACK - NGP50694
#5
#4
#2
#4
#9
#11
#5
#10
#5
#4
Parts List
#6
#1
#3
#8
#7
#6
PARTS
#1
NGP50704 NGP50674 NGP50684 NGP5070 NGP5071
40” x 20” x 4”
1/2” MDF
TABLE BODY
1 pc
#4
BOLT
8 pcs
#2
5.25” x 3” x 3”
ABS Plastic
LEG
4 pcs
#5
FLAT WASHER
8 pcs
#3
8” x 3.25” x 2.5”
ABS Plastic
GOAL
2 pcs
#6
1/2” SCREW
4 pcs
#7
2.875” Dia. ABS
Plastic w/ Felt Pad
STRIKER
2 pcs
#9
HEX WRENCH
1 pc
#8
2.5” Dia. x 1/8”
#11
For replacement parts please call 800-759-0977.
ABS Plastic
PUCK
2 pcs
6mm NUT
8 pc
#10 NGP50801
5 Blade Axial Fan
Pre-installed on
Table Body
BLOWER MOTOR
1 pcs
ADDITIONAL EQUIPMENT
REQUIRED:
PHILLIPS HEAD
SCREWDRIVER
4/14
ASSEMBLY TIPS
1. Find a clean, level surface to begin the assembly of your game table. The table will be
partially assembled upside down and then turned over onto its legs. This is a heavy game
and turning it over will require at least two strong adults.
2. Remove all of the contents from box and verify that you have all of the parts shown on the
Note: Some parts may be pre-installed or
pre-assembled.
understand the text before beginning each assembly step.
4. When installing parts that have more than one screw or bolt, hand tighten all screws or
bolts in place before finishing tightening with screwdriver or hex wrench.
5. Electric screwdrivers may be helpful during assembly; however, please set a low torque
and use extreme caution because screws may be stripped or overtightened if the electric
screwdriver's torque is set too high.
WARNINGS!
READ AND FOLLOW ALL ASSEMBLY, OPERATION AND SAFETY INSTRUCTIONS CAREFULLY.
CHOKE HAZARD - THIS TABLE CONTAINS SMALL BALLS AND PARTS - NOT
SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE.
4
#11
5
1. Attach one LEG #2 to each corner of the TABLE BODY #1 using BOLT #4, FLAT WASHER #5
and NUT #11, which is inserted into back of LEG hole. NOTE: the table is assembled upside down.
2. Carefully turn table over. Attach one GOAL #3 to each end of the table with 1/2” SCREW #6.
Loading...