Powerplay KSP1285 Owner's Manual

OWNER’S MANUAL

54-Key Electronic

Keyboard

PLEASE READ BEFORE OPERATING THIS EQUIPMENT

Model: KSP1285

1

Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency e

nergy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

• Re

orient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B). This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) t

his device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

BATTERY INFORMATION

Adult Installation Required

1. Open the battery compartment door

on the bottom of the unit by removing
the screws with a screwdriver (not
included) and lift up.

2. Insert 4 “AA” size batteries (included)

following the polarity marked inside
the battery compartment.

3. Replace the battery compartment door and the screws.

4. Using a screwdriver, close door.

BATTERY PRECAUTIONS:

Follow these precautions when using batteries in this device:

1. Use only the s

ize and type of batteries specified.

2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery

compartment. Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g., Alkaline and Carbon-zinc) or old

batteries with fresh ones.

4. If the batteries in the device are weak/dead or the device is not to be used for a long period

of time, remove the batteries to prevent damage or injury from possible b

attery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and

rupture. (Follow battery manufacturer’s directions.)

6. Do not dispose of batteries in a fire; batteries may leak or explode.

• Rechargeable batteries are to be removed from the toy before being charged,

• Rechargeable batteries are only to be charged under adult supervision,

• The supply terminals are not to be short-circuited.

AC ADAPTER:

To operate the unit using AC power, connect an AC/DC adapter with DC 6V, 300mA (not
included) to the unit. Plug the small end into the DC 6V Jack on the bottom of the unit
and connect the other end into the AC outlet. The batteries are automatically disconnected
when the AC adapter is used.

CAUTION:

Using an AC adapter that does not have the recommended rating may damage the unit. When
not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not
the cord).

2