POWER ON BOARD Rechargeable Inflator/Spotlight, VEC280FPOB User's Manual & Warranty Information

8

3. If you suspect a bulb is blown, check the bulb filament. If filament is coiled and
unbroken, the bulb is not blown. If filament is blown, replace bulb.

4. If you suspect the main fuse is blown, check it and, if necessary, replace with a
new 20 amp spade fuse.

SPECIFICATIONS

Spotlight: 12 volt H3, 25 watt bulb
Batteries: Two maintenance-free, sealed lead acid,

6 volt, 4.5 Ah
AC Adapter: 1000mA, 12 volt high frequency charger
Operating Voltage: 12 volts DC

VEC280FPOB

USER’S MANUAL

& WARRANTY INFORMATION

IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS

TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.

4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312

Toll Free: [phone]

Rechargeable

Inflator/Spotlight

High Pressure/High Volume Inflator Combo

with 12 Volt DC Portable Power Supply

VEC280FPOB_ManualEN_011306 1/13/06 12:51 PM Page 8

ii

IMPORTANT SAFETY INSTRUCTIONS

WARNINGS

• Contains non-spillable sealed lead acid batteries. They must be recycled or disposed

of properly.

• DO NOT dispose of batteries in fire, as this may result in an explosion.

• DO NOT open battery or short circuit, this may cause the battery to leak or get hot

causing personal injury. Any disposal questions call toll-free [phone].

Spotlight Safety

1. All halogen lights give off heat. Never place the light face-down on any surface when lit.

2. Never look directly into the spotlight or shine the spotlight into another person’s eyes.

3. Replace bulb or batteries with type indicated in Specifications in the User’s Manual.

4. Do not immerse this spotlight in water. This unit is not waterproof.

5. Lens gets very hot – do not touch lens while spotlight is operating.

6. Keep sharp objects away from lens – it is glass and can break.

7. Do not drop or throw spotlight.

8. Do not substitute power cords or charging adapters. Only charge with supplied AC and DC
charging adapters.

9. Do not crush, cut, pull or expose charging adapter cords to extreme heat or sharp edges.

10. Position charging adapter cords so that they do not become entangled or become a safety hazard.

11. Always charge in a dry location.

12. Plug in the charging adapter at the spotlight first, then plug into the charging source.

13. DO NOT OVERCHARGE:
AC recharge up to 10 hours maximum.
DC recharge up to 5 hours maximum.

14. After recharge, disconnect charging adapter and wait 5 minutes before use.

Compressor/Inflator Safety

1. Never attempt to disable or block the inflation and deflation ports while pump is operating.

2. Never cover unit at any time while operating.

3. Never leave the pump unattended while in use.

4. Never allow sand, small rocks or other debris to be sucked into the inflation or deflation ports.

5. Never look into or point the inflator port opening toward anyone’s eyes.

6. Do not use the compressor continuously for longer than 15 minutes. Extended use will cause it to
overheat and can damage the product. After 15 minutes of continuous use, turn the unit OFF and
wait 15 minutes before resuming operation of the compressor.

7. DO NOT overinflate objects or exceed manufacturer’s recommendations for pressure on objects to
be inflated.

THIS UNIT IS NOT A TOY AND SHOULD ONLY BE OPERA TED BY ADULTS. KEEP AWA Y FROM CHILDREN!

Read This User’s Manual Before Using This Unit.

SAVE THESE INSTRUCTIONS

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any inter ference received, including interference that may cause
undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.
Modifications not authorized by the manufacturer void user’s authority to operate this device.

VEC280FPOB_ManualEN_011306 1/13/06 12:51 PM Page ii