PowerMadd PM14259 User Manual

PowerX Scooter Mount

Installation Instructions for Part No. PM14259

HARDWARE INCLUDED: TOOLS REQUIRED:

Qty Description - 10mm wrench
2 Mounting Brackets
2 6mm Bolts
2 Star Washer
2 PowerX Nut

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION!
NOTE: PowerMadd’s Scooter Mount is designed to mount the PowerX handguards (sold separately) to most

any scooter with mirrors mounted to the handlebars.

STEP 1: Remove your mirror bracket from the
mirror mount. Re-install the mirror bracket through
the PowerX Mounting bracket on as shown in Figure

1.
STEP 2: Determine the best location for mounting

the PowerX guard by placing the PowerX Nut in the
front of the handguard and holding it up the bracket
you just mounted to see which holes will work best
for placement. There are two holes on the bracket for
vertical adjustment of the guard, and three holes on
the guard nut for horizontal adjustment.

STEP 3: Once you determined the correct
mounting holes you want to use, thread a 6mm bolt
through the mounting bracket, then a star washer, then
the PowerX guard and then into the PowerX Nut.
NOTE: Make sure the star washer is in between the
mounting bracket and the PowerX handguard; this
keeps the guard in place.

STEP 4: Hold the PowerX guard in position as you
tighten the bolt securely using a 10mm wrench. Then
tighten the mirror mount as well. The guard should
appear as in Figure 2.

Figure 1

Figure 2

LIMITED WARRANTY

POWERMADD warrants this product to be free from defects in material and workmanship under use for the purpose it was intended. POWERMADD shall not be

liable for damage or injury caused by defective materials or workmanship. POWERMADD may elect to repair or replace this product, but is the sole judge of any
defects in their product. This warranty does not cover any labor costs to remove or reinstall this product and is effect for one year from the original purchase date.

®

POWERMADD

IN14259

1-800-435-6881 www.powermadd.com