Powerkiss WCT12W Users Guide
PowerKiss
Wire-free
Charging
PowerKiss Hotspot Positioning Guide
© PowerKiss 2011
2
Contents
PowerKiss wire-free charging 4
Ring 4
Heart 4
Processing 5
Technical requirements 6
I Furniture material 6
II Distance from the user 7
III Space required by PowerKiss Heart 8
IV Distance between two Hearts 9
Fine tuning the place for the Hotspot 10
I Optimal place for the Hotspot 10
II Taking adjacent seats into account 11
III The Edges 12
Examples of positioning the PowerKiss Hotspots 13
Round table 13
Conference table 14
A single-user worktable 15
Summary of the requirements 16
3
PowerKiss wire-free charging
I.T.E.
Wire-free Charging Transmitter
Inp ut: 12 ± 0 .2 V DC / 1.0 A / 12 W
Ind oor use only
Version: 2.1 S /N: A005 00
Heart
+
-
FCC ID: ZMI-WCT12W
Use only with power supplies listed in the manual
Heart
The essence of wire-free charging is the
pairing of Heart and Ring. The Heart is the
transmitter and the Ring is the receiver
and together they enable wire-free
charging on almost any surface.
Ring
The Ring is a small accessory that is
plugged into handheld devices, such as
mobile phones or mp3-players. As soon
as the Ring is plugged in, the device is
ready to be a part of a wire-free energy
To turn a surface into a wire-free charging
platform it first needs to be given a Heart.
Like most, this Heart is also hidden except
for a small LED light to indicate that it is
ready to charge a mobile device wearing
a Ring. The LED is also the center point
of the charging area, called PowerKiss
Hotspot. Whenever the device with Ring
is on this Hotspot, the wire-free charging
begins.
transaction.
4
Processing
As was mentioned in the foreword, the
Heart is installed to a piece of furniture.
There is a special milling that needs to be
done in order to use the Heart properly.
Drawings of the milling are presented in
pictures below.
±1
34
A A
68
±1
±0,5
4
3,5
+
0,1
SECTION A-A
Technical requirements
Also, because of the heating of the
I Furniture material
Due to the characteristics of
electromagnetic fields,
PowerKiss wire-free charging
equipment should not be inserted into
metal surfaces, or other conductive or
highly magnetic materials.
Furniture material should be
PowerKiss Heart and Ring, the material in
which the equipment is inserted, should
be heat tolerant at 80°C. This applies
also for the coating material of the
surface.
The PowerKiss Heart is designed to be
installed into a piece of furniture with
surface thickness of 15-50mm.
• Heat tolerant at 80°C
• Target surface thickness of 15-50 mm
• Not containing metal or conductive material
6
Loading...