PIM
User
[Pick the date]
MOTION
Heated Vest
User Manual v4.5
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
1) Vest only
One heated vest (fig. a)
Two 100cm extension wires (fig. b)
2) Vest with 12v MotionPack batteries
One heated vest (fig. a)
Two 100cm extension wires (fig. b)
1+ MotionPack 12v batteries and charger (fig. c)
3) Vest with 16v MotionPack batteries
One heated vest (fig. a)
Two 100cm extension wires (fig. b)
1+ MotionPack 16v batteries and charger (fig. e)
fig. a
Two 100cm extension wires to be connect to
MOTIONHeat
™
heated glove liners
100cm extension wire fig. b
12v Rechargeable Li-Ion batteries
fig. c
16v Rechargeable Li-Ion batteries
fig. d
Charger (either 12v or 16v)
fig. e
NOTE: The standard packaged content ships
with a North American charger. International
chargers for E.U., Australia, and U.K. are
available upon request.
Congratulations on choosing Canada’s hottest and highest performing MOTIONHeat™ heated vest! This high
performance, technical mid-layer will radiate luxurious and adjustable heat to your upper body and core,
keeping you warm whatever the weather.
MOTIONHeat's unique heating system is comprised of soft, flexible, non-metallic fibers which are sewn into
the vest itself. These generate steady, long lasting heat from our compact, rechargeable, Li-Ion battery
packs.
PACKAGE CONTENTS
Contents will vary depending the configuration you have ordered:
Page 2 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
VEST OVERVIEW
Page 3 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
On the vest there is dual button by the chest area. This dual button
acts as the on/off/temperature control button for the heated vest and
heated insoles (sold separately).
PRESS & HOLD the button for 3 seconds to turn on the heating
element. Once on, tap the button to change heat levels.
PRESS & HOLD again for 3 seconds to turn off.
No Light OFF (NO HEAT)
Red (HIGH HEAT)
Blue (MED HEAT)
Green (LOW HEAT)
HOW TO CONNECT THE BATTERY PACK(S)
The vest contains four zippered battery pockets, two on the front and two on the rear. Only use the
MotionPack batteries included with the vest or purchased from Power in Motion.
1. Open the zipper and retrieve the wire from within the pocket
2. Connect the battery to this wire
3. Replace the connected battery into the pocket and close the zipper
HOW TO: TURN ON THE VEST AND ADJUST HEAT LEVEL
Page 4 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Connect the 100cm extension wires to upper connectors
located at the back of the vest. There are two glove
connectors.
Connect the other end of the extension wires to the
gloves. There are two connector locations on the gloves:
1. Connector located in the glove battery pocket
or
2. Glove external connector [Preferred Method]
The extension wires may seem to be excessive in length
when you first connect your gloves. The extra length
accommodates shortening of wire once outer layer has
been put on.
When ready, PRESS & HOLD for 3 seconds to turn ON
the gloves.
Once ON, tap the button on the gloves to switch heat
levels.
No Light OFF (NO HEAT)
Red (HIGH HEAT)
Blue (MED HEAT)
Green (LOW HEAT)
PRESS & HOLD again for 3 seconds to turn OFF.
NOTE: The heated gloves are not operated from the
vest and are controlled by the buttons located on the
gloves.
HOW TO: CONNECTING MOTION
™
GLOVE LINERS
The heated vest ships with two 100 cm extension cables. Attach these to the male ports on the exterior of your vest,
and run the cables to the heated gloves. The heated gloves receive power from the batteries located in the heated
vest. The heated gloves are operated from the buttons located on the gloves.
Page 5 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Connect the 100 cm extension wires to lower connectors
at the back of the vest. There are two heated footwear
connectors.
Connect the MOTIONHeat™ footwear to the vest
This section of the document will not be ready until we have the product on hand, although we would like to briefly
explain where to make the connection.
--------------
How to Charge the batteries
1. Connect the charger unit to the battery connector.
2. Plug the charger into the wall outlet
3. If your battery is fully discharged, a 12v battery will take up to 6 hours to charge both batteries. And
16v battery will take up 8 – 9 hours to charge both batteries.
4. If you charge only one battery at a time, it will take half of the time.
The light on the charger will be red when the batteries are charging and will turn green when they are fully
charged. The batteries do not have a memory effect so you may use them even after a partial charge.
POWER MOTION offers high amp chargers that will charge the battery 4 times faster. If you require a
shorter recharge time, please contact us to order a high amp charger.
Page 6 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Adjustment for Large or wide body type.
If you are large body type, you need adjust
the strap to the maximum loop position.
If you run out of the strap, use no strap at all,
or use the bottom strap if possible.
Adjustment for Medium size body type.
If you are medium body type, adjust and
secure the Velcro strap to the side strap.
Adjustment for Medium/Small body type.
If you are med/Small body type, you need
adjust the Velcro strap and fasten to the
beginning back of the vest.
HOW TO ADJUST SIZING
Your MOTIONHeat™ heated vest has been designed with a “universal fit” which should accommodate nearly
every body shape and size. To adjust the size to your particular body type, there are two straps on either
side of the vest. Use the elastic straps to either loosen or tighten the vest, and then secure them in place.
It may be easiest to have someone stand behind you to help you adjust the size while you wear the vest.
Page 7 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Adjustment for Extra Small body type
If you are X-Small body type, the side straps fasten to the very back of the vest. Pull the side straps out to tighten the
vest. Fasten one side first to the back of the vest then fasten the second set on top of the first set. See the following
diagram for more detail.
Page 8 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
IMPORTANT WARNING – Avoid Damage by Accidental Turn-on
When you are finished using the heated vest, batteries should ALWAYS be disconnected from
battery connectors. This prevents the vest from turning on by itself and potentially causing
damage.
Here are few related scenarios:
1. When you are traveling, you may pack your vest into the luggage together with the batteries
in the pockets but make sure to disconnect the batteries. The pressure of other items in the
enclosed area could push the button and turn the vest on inside the luggage and start
heating up from the inside. No matter how you pack your vest always disconnect the
batteries first; never leave a battery plugged into the vest.
2. Avoid stacking items on top of the vest when it is not in use. The pressure and weight of
other gear could push the button and cause the vest to turn on without your knowledge. For
example, placing in with other bags in the back seat of your vehicle. Always disconnect the
batteries first.
3. When the heated vest is stored in an enclosed compartment, backpack, hand bag, etc. on
an off-road vehicle such as a snowmobile, dog sled, or any sport that may have bouncing
movement, this can cause surrounding objects inside the compartment to turn on vest.
Always disconnect the batteries first.
IMPORTANT WARNING – Don’t Get Wet
The heating system was designed for safe and reliable use in relatively dry conditions.
DO NOT modify or interfere with the electrical components in the heated vest or battery pack(s). The
heating system, including the battery pack, is not designed to be submerged under water.
If the vest gets wet during use (i.e. heavy sweating or rainy day), detach the battery pack and do not use until
the vest is fully dry.
In addition, the battery pack must never be immersed in water, as this will cause electrical faults. It is
important to keep all electrical parts dry.
IMPORTANT WARNING – DON’T allow the batteries to freeze
Leaving battery exposed to extreme cold temperature will decrease battery efficiency and will
cause long term damage. Keep the battery close to your body during usage. When they are not
being used, store them above freezing temperature.
Page 9 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Hand
Wash
Drip
Dry
Do Not
Bleach
Do Not
Dry Clean
Do Not
Iron
Do Not
Wring
WARNING to reduce the risk of injury, always
unplug the charger and remove the battery pack
from the heated vest before performing any maintenance.
Never disassemble the vest, battery pack, or charger.
Contact PowerInMotion or its dealers for all repairs.
To reduce the risk of personal injury and damage,
disconnect and remove the battery pack from the
battery pocket before washing. Never immerse your
battery pack or charger in liquid or allow liquid to flow
inside them.
If the vest does not operate properly with a fully charged
battery pack, clean the contacts on the battery pack. If the
heated vest still does not work property, return the heated
vest, charger, and battery pack to PowerInMotion or its
dealers for all repairs.
Do not use the battery pack if has become wet.
Keep batteries away from fire and other heat sources to
avoid the risk of explosion. Do not sleep while wearing
heated vest or heated gloves.
Always keep the battery pack out of reach of children.
LIMITED WARRANTY
Every MOTIONHeat
™
product is warrantied to the original purchaser for period of one (1) year after the date of purchase.
Subject to certain exceptions, POWER MOTION will repair or replace any part on MOTIONHeat
™
vest if, after
examination, it is determined by POWER MOTION to be defective in material or workmanship. Return the heated vest to
a POWER MOTION dealer’s location, freight prepaid and insured as required. A copy of the proof of purchase should
be included with the return product.
This warranty does NOT apply to damage that POWER MOTION determines to be from modifications, repairs made or
attempted by anyone other than POWER MOTION personnel. Misuse, neglect, abuse, normal wear-and-tear, or
accidents are not covered in warranty.
Warranty registration is not necessary to obtain the applicable warranty on POWER MOTION heated vest. The purchase
date of the product will be used to determine the warranty period if no proof of purchase is provided at the time when
warranty service is requested.
Off Season Storage
When the winter is over and you no longer need to use the heated vest, remove and fully charge the batteries. Place
the batteries in a cool, dry area. It is VERY IMPORTANT to charge the batteries before storing for long periods of
time. Failing to charge the batteries before storing can SEVERELY decrease the capacity of the batteries.
Care and Washing Guide
IMPORTANT! The Battery Pack must never get wet. Remove the batteries from the vest before laundering.
Your heated vest may be HAND WASHED in cold water and HANG DRY.
Warning
Page 10 of 11
POWER MOTION
176 - 200 Barclay Parade S.W. Calgary, Alberta, T2P 4R5
Info@PowerInMotion.ca , www.PowerInMotion.ca
Telephone: 403-233-8841
Power In Motion
176, 200 Barclay Parade S.W.
Calgary, Alberta
Canada T2P 4R5
Contact Information
First Name:
Last Name:
Daytime Phone:
Evening Phone:
Email Address:
Order Information
Date of Purchase:
Sales#:
Shipping information
Street Address:
City:
State/Province:
Country:
Postal Code:
Product Information
Product Name:
Qty:
RMA Type:
Refund Exchange Repair Other __________________________
Please provide a brief description of the problem:
RETURN AND EXCHANGE POLICY
All MOTIONHeat™ products may be returned for a full refund or exchange within 30 days from the date of purchase
provided that all components are in new condition.
Vest has to be in original condition when returned for refund. Stains, fabric damage, it is not acceptable for return or
refund.
WARRANTY or RETURN FORM
Complete this form and send item via tracked package to:
Today’s Date : _____________
Page 11 of 11
Loading...