Power Idea Technology RG850 User Manual

2

1

8

7

10

11

3

4

5

6

SIM/MICRO SD

. 2.

1

. 4.

3

9

IM

S

o

r

ic

m

D

S

2

ENGLISH

KEYS AND SPECIAL FEATURES (see illustration on page 2)

1_EARPHONE JACK

2_SECONDA RY MIC

3_VOLUME UP/DOWN

4_POWER KEY: Long press to power ON/OFF the device.

Short press to power ON/OFF the screen.

5_MAIN MICROPHONE

6_USB-C 2.0 POR T: For charging the phone and to connect to

other devices with the included USB cable.

7_FRONT CAMER A

8_FRONT SPEAKER

9_SIM CARD TRAY

10_MAIN CAMERA

11_CAMERA FLA SH / TORCH

1. INTRODUCTION

This document contains information and safety re gulations which are to be
observed without fail for safe operation of the device RG850 under the described
conditions. Non-observance o f this information and instructions c an have serious
consequences and/or may violate regulations.
Please read the manual and these safety inst ructions before using the device. In
case of any doubt , the English version shall apply.
The current EU-declaration of conformity, sa fety instructions and manuals can
be found at www.ruggear.com, or requested from Po wer Idea Technology

(Shenzhen) Co., Ltd.

2. RESERVA TION
The content of this document is presented as it currently exists. Power Idea
Technology (Shenzhen) C o., Ltd. does not provide any explicit or tacit guarantee

for the accuracy or completeness of the content of this document, including, but
not restric ted to, the tacit guaran tee of marke t suitability or fitness for a speci fic
purpose unless applicable laws or court decisions make liability m andatory.
Power Idea Technology (Shenzhen) Co., Ltd. reserves the right to make
changes to this document or to withdraw it any time without prior notice.
Changes, errors and misprints may not be used as a basis for any claim for
damages. All rights reserved.
Power Idea Technology (Shenzhen) Co., Ltd. cannot be held responsible for
any data or other loss an d direct or indirect damage s caused by any improper
use of this device .

3. EU-DECLARA TION OF CONFORMITY

The EU-declaration of conf ormity can be found at the end of this manual.

4. FAULTS AND DAMAGES

If there is any reason t o suspect that the sa fety of t he device has been
compromised, it must be withdrawn from use immediately. Measures must be
taken to prevent any accidental rest arting of the de vice. The safe ty of the device
may be compromised, if , for example:

• Malfunctions occur.

• The housing of the device shows damage.

• The device has be en exposed to excessive loads.

• The device has been stored improperly.

• Markings or labels on the de vice are illegible.
We recommend that a de vice displaying errors or in which an error is suspected
be sent back to Power Idea T echnology (Shenzhen) Co., Ltd. to be checked.

5. FURTHER SAFETY ADVICE

• Do not touch the scr een of the device with sharp objec ts. Dust particles and
nails may scratch the screen. Please maintain the screen clean. Remov e dust on
the screen with a soft cloth gently, and do not scratch the screen.

• Do not put the device in environments with excessive temperatures, as this

3

• Do not charge the device in environments with much dust or humidity.

• Do not use the de vice in areas where regulations or leg islatives prohibit the use.

• Do not expose the de vice or charger to strong magnetic fields, such as are
emitted from induction ovens or microwaves.

• Do not attempt to open or repair the device. Improper repair or opening can
lead to the destruc tion of the device, fire or explosion. Only authorized
personnel are allowed to repair the device.

• Only use accessories approved by Power Idea Technology ( Shenzhen) Co.,

Ltd.

• Power off the device in hospitals or other places where the use of mobile
phones is prohibited. This device may affect proper work of medical equipment,
such as pacemakers. Always keep a distance of at least 15 cm between the
device and these dev ices.

• Make sure the v olume level is not set too high when plugging
earphones and headphones to pro tect your hearing.

• Observe all corresponding laws that are in force in the respective countries
regarding the use o f devices while operating a vehicle.

• Please power off the device and disconnect the chargin g cable before cleaning
the device.

• Do not use any chemical c leaning agents to clean the device or the charger. Use
a damp and anti-s tatic soft cloth for cleaning.

• Adapter shall be installed near the equipment and shall be easily accessible

• The product shall only be connected to a USB interface of version USB2.0.

• Do not discard old and abandoned li thium batteries into the trash, send them
to designated waste disposal locations.

• The user alone is responsible for any and all damages and liabilities cause d by
malware down-loaded when using the network or other data-e xchange
functions of the device. Power Idea Technology (Shenzhen) Co., Ltd. cannot
be held responsible for any of those claims.

Warning
Power Idea Technolog y (Shenzhen) Co., Ltd. will not assum e any liability for

damages caused by disregar ding any of these adv ices or by any inappropria te
use of the devic e.

6. MAINTENANCE/REPAIR

Please note any legal requirements for periodic inspection. The device i tself has
no user-serviceable par ts. It is recommended to perform inspections according
to the safet y regulations and advises. If there is a problem with the devic e, please
contact your v endor or consult the s ervice center. If your device is in need of
repair, you can either contact the service center or your vendor.

7. BATTER Y

The battery is not fully charged when the device is purchased, but it cont ains
enough energy to power on the de vice. To obtain b est battery performance and
battery life , let the battery discharge completely before charging it completely for
the first three charging cycle s.
The device may only be charged at ambient temper atures in a range fro m +5°C
... +35°C. The phone's normal operating tempera ture is -20 °C to +55 °C. In
order to ensure the normal phone functions , do not use this phone outside the
temperature r ange.

Caution:

Risk of explosion if battery is replaced by an incorrect type. Dispose used
batteries according to the instructions.
RG850 support s 5V/2A charging, usin g any higher charging curr ent may dama ge
your phone.

8. INSTALLATION OF THE NANO SIM CARD (see illustration on page 2)
The device has two slots for nano SIM cards. This is located on the left side of the
unit. Use the ejector pin to access the SIM card slot until the SIM card tray ejects.

Warning

Do only change the SIM card when the device is switched off. Do not try to insert
or remove the SIM car d when any external power supply is connec ted, otherwise
the SIM card may be damaged.

9. INSTALLATION OF THE MICROSD CARD (see illustration on page 2)
The device supports microSD card (up to 128GB). It located in the SIM card tray.
SIM slot 2 can support eit her a microSD card or an addi tional SIM card. Example:
one SIM card and microSD, or two SIM cards and no microSD.

.

EN

4

Warning

Do only change the microSD c ard when the device is switched off. Do not try to
insert or remove the microSD card when any external power supply is connected,
otherwise the microSD card may be damaged.

10. RECYCLING

The crossed-out w heeled-bin symbol on your pr oduct, battery , literature, or
packaging reminds you that all electrical and electronic products, ba tteries, and
accumulators mus t be taken to separate co llection at th e end of their working
life. This requirement applies in the European Union. Do not dispose of the se
products as unsorted municipal waste.
Always return your used electronic products, batter ies, and packaging mat erials
to dedicated collect ion points. This wa y you help prev ent uncontrolled was te
disposal and promo te the recycling o f materials.
More detailed information is available from the product re tailer,
local waste authori ties, national producer responsibility
organisations, or y our local Power Idea Technology

(Shenzhen) Co., Ltd. repr esentative.

11. INFORMATION CONCER NING CE SAR CERTIFICATION

(Specific Absorption Rat e)
The SAR limit of Europe is 2.0 W/kg. The device has also been tested against this
SAR limit. T he highest S AR value r eported under this standard during product
certification for use at the ear is 0.762 W /kg and when properly w orn on the
body is 1.027 W/kg. This device was test ed for typical body -worn operations with
the back of the handset kept 5mm f rom the body. The device complies with RF
specifications when the dev ice used at 5mm from your body . The use of belt
clips, holster s and similar ac cessories sho uld not contain metallic compone nts in
its assembly. The use of accessories that do not sat isfy these r equirements may
not comply with RF exposure require- ments, and should be avoided.

12. FCC CAUTION

Any Changes or modif ications not expressl y approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with par t 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not c ause harmful interference, and
(2) this device must accept any interference rec eived, including interf erence that
may cause undesired operat ion.

NOTE:

This equipment has be en tested and f ound to comply with the limits for a Class
B digital dev ice, pursuant to part 15 of the FCC Rules . These limits are designed
to provide reasonable protection against harmful interfer ence in a residential
installation. This equipment gener ates, uses and can r adiate radio frequenc y
energy and, if not installed and used in accor dance with the instruc tions, may
cause harmful interfer ence to radio communications. However, ther e is no
guarantee that interf erence will not occur in a particular installation. If this
equipment does cause harmful interference to radio or telev ision reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or reloca te the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

SPECIFIC ABSORPTION RATE (SAR) INFORMAT ION

SAR tests are conducted using st andard operating positions accepted by t he
FCC with the phone transmitting at it s highest certif ied power level in all tested
frequency bands, although the SAR is det ermined at the highest certified power
level, the actual S AR level of the phone while operating can be well below t he
maximum value. Before a new model phone is a available for sale to the public,
it must be tested and certified to the FCC that it does not exceed the exposure
limit established by the FCC, tests for each phone are performed in positions and
locations as required by the FCC.
For body worn operation, this model phone ha s been tested and me ets the FCC
RF exposure guidelines when used w ith an accessory desig nated for this product
or when used with an accessory that contains no metal and tha t positions the
handset a minimum of 1.0cm from the bod y. Non-compliance w ith the abov e

5

restrictions may r esult in violation of RF exposure guidelines

ISEDC WAR NING

This device complies wi th ISEDC license-exempt RSS standard(s). Operation is
subject to the f ollowing two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference tha t may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISEDC applicables aux appareils
radio exempts de licenc e. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil nedoit pas produire de brouillage , et
(2) l'utilisateur de l'appareil doit accepter tout br ouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le f onctionnement
This Class B digital apparatus complie s with Canadian ICES-003 .
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.

SAR tests are conducted using st andard operating positions accepted by t he
ISEDC with the phone transmitting at its highest cert ified power level in all tested
frequency bands, although the SAR is det ermined at the highest certified power
level, the actual S AR level of the phone while operating can be well below t he
maximum value. Before a new model phone is a available for sale to the public,
it must be tested and certified to the ISEDC that it does not exceed the exposure
limit established by the ISEDC , tests for each phone are performe d in positions
and locations a s required by the ISEDC.
For body worn operation, this model phone has been tested and meets the ISEDC
RF exposure guidelines when used w ith an accessory desig nated for this product
or when used with an accessory that contains no metal and tha t positions the
handset a minimum of 1.0cm from the bod y. Non-compliance w ith the abov e
restrictions may r esult in violation of RF exposure guidelines
Le présent appareil est conforme
Après examen de ce ma tériel aux conformité aux limites DAS et /ou aux
limites d’int ensité de champ RF, les utili sateurs peuv ent sur l’ exposition au x
radiofréquences et la conformité and c ompliance d’acquérir les infor mations
correspondantes

13. TRADEMARKS

• Google™, Google Play and Android are trademarks of Google Inc.

• All other trademark s and copyrights are the properties of their respective
owners.

.

EN

6

Power Idea Technology (Shenzhen) Co., Ltd.

4th Floor, A Section, Languang Science&technology

Building, No.7 Xinxi RD, Hi-Tech Industrial Park North,

Nanshan District, ShenZhen, P.R.C.