Power-Flo Technologies PFWRC3737C1F, PFWRC3737C2F, PFWRC3737B1F, PFWRC2017C1F, PFWRC2727C1F User Manual

...
OWNER’S MANUAL
Wet Rotor Circulator Pumps
For Indoor Use Only
Maintenance Free
“Power-Flo Pumps & Systems, Your Power-Ful partner for all your pumping needs”
Power-Flo Pumps & Systems 877-24PUMPS www.poweropumps.com
ISP No: Circulator - 10/13/15
Wet Rotor Circulator Pumps
General Safety Information
Before installation, read the following instructions carefully. Failure to follow instruction and Safety information could cause serious bodily injury, death and/or property damage. Each Power-Flo pump is individually factory tested to insure proper performance. Closely following these instructions will eliminate potential operating problems, assuring years of trouble-free service.
Installation, wiring, and junction connections must be in accordance with the National Electric Code and all applicable state and local codes. Requirements may vary depending on usage and location.
Installation and servicing is to be conducted by qualied personnel only.
This pump is not intended for use in
swimming pools, spa areas or water installations where human contact with pumped uid.
Features:
Power-Flo circulator pumps are low noise, low leakage, reliable operation and easy installation. Single and three speed compact, ecient wet rotor circulators for closed loop (cast iron volute) hydronic heating and cooling circulation and open loop (bronze and stainless steel) domestic water recirculation applications.
MOTOR: 2-pole, 3600rpm, single phase, PSC with Thermal protection
LIQUID TEMPERATURE: 32°F - 230°F
MAX. SYSTEM PRESSURE: 145 PSI
INSULATION: Class H
Risk of electric shock. To reduce risk of
electric shock, always disconnect pump from power source before handling. Lock out power & tag.
In the event the
retaining screws have been pulled out of the housing, DO NOT replace them. Use of any other screw may short out the stator
windings, creating a risk of electrical shock.
The addition of
petroleum based uids
or certain chemical additives to the system voids the warranty.
Pumps build up heat and pressure during operation. Allow time for pumps to cool before handling or servicing.
Receiving Inspection
Upon receiving the pump, it should be inspected for damage or shortages. If damage has occurred, le a claim immediately with the company that delivered the pump. Care should be taken to ensure the pump is NOT dropped or mishandled, dropping will damage the pump. If the manual is removed from the packaging, do not lose or misplace.
® Power-Flo is a registered trademark of Power-Flo Technologies Inc. Alteration Rights Reserved. 3/15, 10/15
Power-Flo Pumps & Systems • 877-24PUMPS • www.poweropumps.com
2
Wet Rotor Circulator Pumps
Dimensions
A
C
B
E
D
F
SINGLE SPEED
VOLUTE
MODEL NUMBER
PFWRC3737C1F Cast Iron 115/1 3.0 335 Closed 6-1/2 6-3/8 5-1/16 5-3/8 3-1/4 3-5/32 12.5
PFWRC3737C2F Cast Iron 230/1 1.5 335 Closed 6-1/2 6-3/8 5-1/16 5-3/8 3-1/4 3-5/32 12.5
PFWRC3737B1F Bronze 115/1 3.0 335 Open 6-1/2 6-3/8 5-1/16 5-3/8 3-1/4 3-5/32 12.5
Material
VOLTS/ PHASE
AMPS WAT TS
SYSTEM
TYPEAFace/Face
B C D E F
THREE SPEED
VOLUTE
MODEL NO
PFWRC2017C1F Cast Iron 115/1 0.9/0.7/0.5 100/70/55 Closed 6-1/2 5-7/16 4 5-1/8 3 3-5/32 7.25
PFWRC2727C1F Cast Iron 115/1 1.6/1.5/1.3 185/170/135 Closed 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC2727C2F Cast Iron 230/1 .8/.75/.65 185/170/135 Closed 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC2727B1F Bronze 115/1 1.6/1.5/1.3 185/170/135 Open 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC3032C1F Cast Iron 115/1 1.8/1.7/1.2 200/190/135 Closed 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC3032C2F Cast Iron 230/1 .9/.85/.6 200/190/135 Closed 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC3032S1F Stainless 115/1 1.8/1.7/1.2 200/190/135 Open 6-1/2 6 4-3/4 5-5/16 3-1/4 3-5/32 11.25
PFWRC2644C1F Cast Iron 115/1 2.0/1.7/1.2 230/190/135 Closed 8-1/2 6-11/16 5-1/8 5-5/8 3-1/4 3-7/16 13.5
PFWRC2644C2F Cast Iron 230/1 1.0/.85/0.6 230/190/135 Closed 8-1/2 6-11/16 5-1/8 5-5/8 3-1/4 3-7/16 13.5
PFWRC2644B1F Bronze 115/1 2.0/1.7/1.2 230/190/135 Open 8-1/2 6-11/16 5-1/8 5-5/8 3-1/4 3-7/16 13.5
Material
VOLTS/ PHASE
AMPS WATT S
SYSTEM
TYPEAF/F
B C D E F
WT.
lbs
WT.
lbs
PF WRC 21 20
Shut O
Power-Flo Wet Rotor Ciculator
EXAMPLE: PFWRC2120C1F - Power-Flo Pumps - Wet Rotor Circulator - 21” Shut O Head - 20GPM Max Flow - Cast Iron Volute - 115 Volt, Flanged Connection.
Power-Flo Pumps & Systems • 877-24PUMPS • www.poweropumps.com
Head (ft)
Max Flow
(Gal)
Volute Material
C, B, S
C = Cast Iron B = Lead Free Bronze S = Stainless Steel
Motor Voltage
1 or 2
1 = 115 V 2 = 230V/1P
Connection Type
F, S, U
F = Flanged S = Copper Sweat U = Union
3
Loading...
+ 5 hidden pages