Powercall DX-5200 TB3.7 User Manual

WARNING TO ALL

POWERCALL

INSTALLERS

It is IMPERATIVE that you check your speaker wiring of your unit before

installing our siren. If you are replacing an existing unit, the speaker wiring

may not be the same. This could damage your siren beyond repair.

ENSURE THAT YOUR 2 SPEAKER WIRES FROM

YOUR SPEAKER ARE GOING DIRECTLY TO THE

SPEAKER 1+ AND 1– OR SPEAKER 2+ AND 2-.

DO NOT CROSS THEM, WIRE THEM IN

PARALLEL, SERIES OUR COMMON. SPEAKERS

ARE A DIRECT WIRE INSTALLATION.

Powercall DX-5200

TB3.7 200/100 Watt

Electronic Siren

Thank you for your purchase of the new Powercall DX5200 TB3.7 Electronic Siren. This
siren has the “Old School” tones that has been highly requested by our customer base.

This is a 200 Watt siren that can be wired for 100 Watts using 1 speaker

or 200 watts using 2 speakers. See enclosed for more information.

The DX5200 has a directly connected Terminal Strip on the bottom of the siren for easy
connections and less hassle than the older wiring harness sirens. We recommend using
crimp connectors with your siren vs. sticking the wire under the screw. If you do not use
the U crimp connectors, be sure that wiring does not fray out and touch another terminal.

This product is designed, built and serviced by Powercall Sirens LLC
12 volts / 100/200 Watts
Current Draw: 15A Average / 20A Max