Power Acoustik PMD-112CMX User Manual

PMD-112CMX

11.2 TFT-LCD DVD/SD/USB COMBO MONITOR

PLAY

POWER

OWNER S MANUAL

Contents

Caution Features and Controls

Monitor/DVD Player Remote Control

Power and Mode Selection ReleasingTheMonitor Turningon The Monitor Mute Function

AVmode

Picture Control Contrast/Brightness/Color/FM

DVD Setup Setup Menu General Setup TVAspectRatio

Angle Viewing OSD Language Screen Saver

Audio Setup Dolby Digital Setup Equalizer Settings VideoSetup Quality Preferences Setup TVType

PBC Audio Subtitle Disc Menu Parental Default Password Setup

Password Mode Password Change DVD Functions

Eject Vol+/Vol-

Mute

Play or Pause

Audio

Stop

Arrows

Setup

Display

Number Buttons Subtitle

Title

Slow

Fast Reverse Searching

Fast Forward Searching

RepeatA-B

Repeat

NTSC/PAL

Angle

PBC

Zoom

GOTO

SD/USB Functions

18 21

Connection Diagram

21 21

Installation

21 21

Disc Information

Troubleshooting

22 22

Specifications

23 23

23 24 24 24

24 24

24 25

25 25

25 26

26 27 27 27 28 28 29 29

29 30 30

30 31 31 31

32 33

34 35

36 37

Caution

Please read and observe all warnings and instructions in this manual and those marked on the unit. Retain this booklet for future reference.

There are two kinds of alarm symbols as follows:

The lightning bolt with arrowhead inside in an equilateral

WARNING

CAUTION

O W

E R

MEN

triangle is intended to alert the user to the presence of

dangerous voltage within the product s enclosure that may be

＂＂

of sufficient magnitude to constitute a risk of electric shock to people.

The exclamation point inside an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

WARNING

Installation of all TV monitors must be out of the driver s field of vision.

Do not mount the product where it will obstruct the deployment of the airbag or in an area where it would affect the driver sability to control the vehicle.Also be careful to avoid mounting the product where it can become hazardous during sudden stops or in the event of an accident.

SPECIFICATIONS

Power

Screen Format

Resolution Pixel

Color System

A/V Input

A/V Output

Dimension

Note:This equipmenthas beentested andhas beenfound tocomply with the limits for a ClassAdigital device,pursuant topart 15of the FCC Rules. Theselimits aredesigned toprovide reasonableprotection against harmful interference when the equipment is operated in a commercial environment. Thisequipment generates,uses, andcan radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference

’

to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference. In some cases, the user will be required to correct the interference at his own expense.

DC 12V 16:9 2400x480 NTSC/PALAuto Select DVD-AV1-AV2 1EA With shroud:14.6(L)X12.6(W)X3.3(H)inches

Without shroud:14.3(L)X12.4(W)X2.4(H)inches

Do not try and service these products yourself, a qualified service center or factory service center for all repairs.

Be careful not to drop or apply under pressure to the front panel of your video monitor.If the screen cracks due to misuse, your warranty will be void!

locale

Use extra caution with any liquids in your car. Ifyou or your child spills any liquid on these products, pull your vehicle to the roadside

or wipe the products with a towel. Do not operate the equipment until all liquids have either evaporated or you have had the monitor inspected at a service center by a qualified technician. Severe harm or danger can result.

and turn the key offto disconnect

Use only a damp cloth to clean the screen and use only purified water on the cloth. wring out all excess water prior to wiping the screen. Do not use any cleaners or chemicals to clean the screen. In most cases a dry cloth will do!

Troubleshooting

Caution

CAUTION

Symptom

Buttons do not work.

No sound

Remote control does not work properly.

Items to Check

Is the power turned on?

Is the audio which is connected with the audio cable set to receive the DVD signal output?

Is audio cable connected securely? Is the monitor which is connected

with the audio cable turned on? Is the audio output set

in the correct position?

Is the remote control facing the remote sensor?

Is the distance too far? Is there any obstacle in the middle? Is the battery weak?

Actions to beTaken

Check the car battery capacity.

Select the correct input mode for the audio receiver. Connect the audio cable into the jacks securely. Turnon the monitor connected with the audio cable. Set the Audio Output to the correct position,

and then turn on the DVD player again by pressing the POWER button.

Point the remote control toward the remote sensor of the product.

Use the remote control within 15 feet. Remove the obstacle. Replace with new battery.

Moisture or condensation on lens

When a disc is brought from a cold environment to a warm one, there may be moisture on the the disc, or condensation on the pickup lens. It will affectdiscplayback.

1. Remove the disc from the DVD player.

2.Turnon the power and leave it on for an hour to vaporize the condensation.

Quality installations are best performed by qualified and certified installers.

，

Don t touch the unit if there is a flash of lightning.You may receive an electric shock.

Do not cover or stop up heater ducts or vents. It may cause a fire or receive an electric shock.

Watchingthe monitor for an extended period of time without the engine running may deplete the vehicle s battery charge.

This product is designed for operation with a 12 VoltDC, negative ground vehicle. It is not suitable for operation under other conditions or voltages.

Do not bring magnetic devices such as credit card or magnetic card near the magnets.

，

Operating Notes

1.The operating temperature ofthis product is limitedto 14 ~+140 F.

2. If your vehicle is extremely hot or cold you must allow time for your air conditioner or heater to cool or heat the vehicle until operating temperatures have returned to normal operating ranges.

3. Optimal picture quality is achieved when viewed from directly front of the monitor (+/-30degrees).

4. Do not open the housing and attempt to make any repairs yourself. Refer servicing to qualified personnel.

5. DVD Players use an invisible laser beam which can cause hazardous radiation exposure. Be sure to operate the unit correctly as instructed.

6. Do not cut the car power supply offwhile a disc isplaying. It can cause damage to the DVD Player.

7. If the buttons get stuck, please try to press the up of buttons, it will get back. It won't impact using normal.

8. If you cann't find the files name in list when playing, please reset units or turn off/on over again.

9. If the unit cann't be change mode when playing some special files which the unit didn't support, please reset units or turn off/on overagain.

Features And Controls

Disc Information

Monitor/DVD Player

Vol-

PLAY

Vol+

MONITOR

Remote Control

DVD features

DVD discs provide high-resolution images with high-quality sound. ThisDVD player can play not only DVD discs of various versions, but also S-VCD, VCD, audio CD and MP3 discs.

Discs that cannot be played

DVD-RW,DVD-REM, CD-ROM,CD-EXTRAdiscs cannot be played on this unit. In addition, a CD or a CD-RW which was recordedon special software cannotbe played.

Region code

Your DVD player is designed and manufactured to region management information that is recorded on a DVD disc. Please check the region code. 1: NorthAmerica 2: Japan 3: Korea andSoutheastAsia 4:Australia, Mid & SouthAmerica 5: Russia 6: China

How to handle the disc

，

POWER

Monitor/DVD Player

Don t touch the shiny side of the disc (the side with the embedded information).

，

Don t stick a label or a glue-based note on either side of the disc.

，

Don t use discs that have glue or a damaged label with exposed adhesive residue. It might result in damage to your DVD player.

，

Don t put discs in the sunshine. Park your car in the shade.

How to handle the discs

Only use round discs. Discs with other shapes like a star, a heart, etc. may cause damage to the player. If a disc is dirty,wipe softly with a wet cloth and then with a dry one. Before playback, wipe the disc outward from the center with a clean cloth. Do not use any type of solvent such as thinner, benzene, commercially available cleaners or antistatic spray.Toavoid damaging your DVD player, don t usea scratched disc.

，

Wireless Headphones (Not Included)

Installation

Features And Controls

1. Open the package and check that these items are presents.

INSTALLATION PLATE

UNIT

SCREWA SCREW B

2. Connect the external compoments to the RCA cable or AVoutput. (Refer to the connection diagram on page 33)

3. Match the position of installation bracket and installation plate with screw A.

PLAY/PAUSE Button

PLAY

POWER

MENU Button

Dome Light Button

ON DOOR OFF

Skip Forward/Back Button

AV Select Button

POWER Button

+/- Buttons

POWER

EJECT Button

Disc loading slot

4.Tightenthe unit with the supplied screw B.

USB

SD Input USB Input

Caution

Do not bring magnetic devices such as credit cards or magnetic cards near the monitor.

Audio Video

AV2I NPUT S

RESET

+ 15 hidden pages