Pottery Barn Windsor Side Table with Shelves Assembly Instruction
pottery barn kids
WINDSOR SIDE TABLE WITH TWO SHELVES
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions carefully before assembling.
For your safety, assembly by two people is recommended.
PARTS INCLUDED:
(A) Table Top – 1pc
(B) Center Shelf – 1pc
(C) Bottom Shelf – 1pc
(D) Leg Panel – 2pcs
PRE-ASSEMBLY:
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface,
as this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.
• Use the parts and hardware lists above to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.
ASSEMBLY INSTRUCTIONS:
1. Careful l y pl a ce ( 1) L e g P a ne l (D ) o n y ou r w o rk s ur f a ce . Align the Center Shelf (B) and Bottom Shelf (C)
with the pre-drilled holes on one of the Leg Panels (D), securing with Bolts (F), Spring Washer (G) and
Flat Washer (H). Tighten the bolts using the included Allen key (D). (Fig. 1)
HARDWARE ENCLOSED:
(E) Allen Key
(F) Bolt ¼“ x 20mm
(G) Spring Washer ¼“
(H) Flat Washer ¼“
– 1pc
– 12pcs
– 12pcs
– 12pcs
(Fig. 1)
B.
C.
H.
G.
F.
D.
E.
2. Align and attach the remaining Leg Panel (D) with the pre-drilled holes on the assemble d piece, securing
with Bolts (F), Spring Washer (G) and Flat Washer (H) in place. Tighten the bolts using the included Allen
key (D). (Fig. 2)
(Fig. 2)
D.
H.
G.
F.
E.
3. Turn the Table Top (A) upside down. Align the assembled piece over the pre-dril led holes on the Table
Top and secure with the remaining Bolts (F), Spring Washers (G), and Flat Washers (H). Tighten the bolts
using the included Allen key (D). (Fig. 3)
4. Check the alignment before fasten all the bolts. Place the assembled table upright to enjoy.
Loading...