Pottery Barn Train Engine Trundle Assembly Instruction
pottery barn kids
TRAIN ENGINE TWIN TRUNDLE
PRE-ASSEMBLY
• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work
surface. This will avoid damaging any parts during assembly. T he shipping box provides an i deal work
surface.
• Do not dispose of any contents until as sembly is completed to avoid accidentall y discarding small parts
or hardware.
• Use the parts and hardware lists above to identify and separate each of the pieces included.
• The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.
PARTS INCLUDED:
(A) Side Bottom Board
with Protruding Edge - 2pcs
(B) Middle Bottom Board
with Sunken Edge - 1pc
(C) Wooden Rail - 2pcs
(D) Long Side Rail - 2pcs (E) Short Side Rail - 2pcs
HARDWARE INCLUDED:
(F) Phillips Head Screw #8x30 mm
-22pcs
(I) Caster 40x60x65mm - 6pcs (J) Pan Head Screw #4 x 12 mm -
TOOLS REQUIRED:
• Screwdriver (Not included)
• Phillips Head Screwdriver (Not included)
(G) Barrel Nut 6x13x10mm - 8pcs (H) Allen Bolt M6 x 60 mm - 8pcs
24pcs
(K) Allen Key - 1pc
1/3
ASSEMBLY:
1. Slot the Middle Bottom Board (B) into the two Side Bottom Boards (A) with the pre-drilled holes on the Side
Bottom Boards facing up. Attach the Wooden Rails (C) to the assembly by inserting the wood dowels on the
Wooden Rail into the pre-drilled holes on the Side Bottom Boards as shown. Secure the Wooden Rails by
using twelve (12) Phillips Head Screws #8x30mm (F) . See Fig. 1.
Fig. 1
Dowel under
Wooden Rail
Pre-drilled Hole
on Bottom Boards
A
F
C
B
C
2. Turn the assembled bottom boards over and attach the Long Side Rails (D) and Short Side Rails (E) to
bottom boards as shown. Connect rails by using two (2) Barrel Nuts (G) and two (2) Allen Bolts M6x60mm
(H) at each corne r. Secure Allen Bolt s with enclosed A l len K e y (K ). See Fi g 2.
Fig. 2
D
E
K
D
E
Groove on Long and Short Side Rail
cut for Bottom Board
2/3
Loading...