Pottery Barn Train Engine Bed Assembly Instruction

pottery barn kids

TRAIN ENGINE TWIN BED

PRE-ASSEMBLY:

• Please read all instruction before beginning assembly. The illustrations provided allow for easier
assembly when used in conjunction with the assembly instructions.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface, as this
will avoid damaging any parts during assembly. The shipping box provides and ideal work surface. Do not
dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• For your safety and ease, adult assembly by two people is recommended.

• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting
assembly.

• Note: DO not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.

PARTS INCLUDED:

A - Headboard (1 pcs) – Box 1 B - Footboard (1 pcs) – Box 2

E - Cart (1 pcs) – Box 3

C - Side Rail (2 pcs) – Box 4

HARDWARE ENCLOSED:

F - Wood Screw, 8 x 25 mm (32 pcs) – Box 1

TOOLS REQUIRED:
Phillips Head Screwdriver (Not included)

D - Slat Roll (1 pcs) – Box 4

Page 1/3

A

ASSEMBLY INSTRUCTIONS:

1. Attach both Side Rails (C) to the Headboard (A) and Footboard (B) by insertin g the hooks at two ends of Side
Rail (C) into the slots on Headboard (A) and Footboard (B). Press down firmly to se cure. Ensure that the
decorative molding at one end of side rail is continuous to the decorative molding on the Headboard (A).
Change the Side Rail (C) to opposite side if the decoration does not align. (Fig. 1)

Figure 1

Decorative molding at one end of side rail must be continuous
to the decorative molding on the Headboard (A).

B

C

2. Lay the Slat Roll (D) between the Side Rails (C). Insert the Wood Screws #8 x 25 mm (F) into the
pre-drilled holes on each rail and secure with Phillips Head Screwdriver. (Fig. 2)

F

Figure 2

D

Page 2/3