Pottery Barn Thomas Media Hutch Assembly Instruction

pottery barn kids

A

A

K

KJLBA

thomas wall media hutch

• Please read all instructions carefully before beginning assembly.

• For your safety, assembly by two people is recommended.

• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.

• Phillips head screwdriver not included.

Parts Enclosed: Hardware Enclosed:

• (1) Top Panel (A)

• (1) Crown Frame (B)

• (2) Divider (C)

• (2) Side Panel (D)

• (1) Shelf (E)

• (1) Back Panel (F)

• (1) Adjustable Shelf (G)

• (1) Back Slot (H)

ASSEMBLY:

D G

F H

BC

C

E

1. Carefully lay the side panel (D) on scratch- free
surface such as a rug or carpet. Attach the shelf (E)
to the side panel using the wooden dowels as
guides. Use CBS screw (K) to fasten the connection
with screw driver. Repeat the same procedures for
the opposite side of the panel. Attach the dividers
(C) to the shelf and carefully slot down the dividers

The use of power tools during the assembly of this item can cause the hardware to strip or the wood to split. Please proceed with
extreme care.

CARE:
To clean, wipe with a soft dry or slightly damp cloth.

until fully secure into the shelf.

I

OM

2. Gently locate the pre-drilled hole of the crown frame
and attach it to the side panels and dividers using
the wooden dowels as guides. Use flat washers (O),
spring washers (N), and JCBCW screws (M) to
fasten the connection with the Allen Key (P). Attach
the top panel onto the crown frame. Use CBS
screw (I) to fasten the connection as shown.

D

N

P

• (11) CBS M3 x 16mm (I)

• (5) CBS M4 x 20mm (J)

• (6) CBS M4 x 30mm (K)

• (4+2) Shelf Support (L)

• (8) JCBCW M7 x 95mm (M)

• (8) Spring Washer M6 (N)

E

• (8) Flat Washer M6 (O)

• (1) Allen Key (P)

3. Carefully lay the hutch on scratch-free surface. Slot in the
back panel (F) into the grooves designed into the side
panels until it seats inside the top crown. Use CBS screw
(K) to fasten the bottom part of the back panel to the side
panel with screwdriver. Fasten the connection of the back
panel to the internal shelf and divider using CBS screw (J).

H

4. Gently grip the hutch at each end and bring it upright. If
you wish to cover the window on the back panel, proceed
with the following step. Raise the back slot (H) until the
bottom of the slot panel clears the bottom of the opening
allowing it to seat inside the groove at the top of the
opening. Now lower the slot panel allowing it to rest into
the groove at the bottom of the opening. Determine the
desired height for each shelf. Insert the shelf supports (L)
into the pre-drilled holes as shown. Carefully insert the
shelf (G) into the hutch and gently rest it on the shelf
supports as shown.

Assembly is complete.

F

ssembled

G

Thank you for your purchase