Pottery Barn Thomas Dresser Topper Assembly Instruction

pottery barn kids

THOMAS CHANGING T ABLE T OPPER

! WARNING

FALL HAZARD

reach.
z Read all instructions before use of the changing table. KEEP INSTRUCTIONS FOR FUTURE

USE.

z Before each use check the changing t able for damage, loose parts, or sharp edges. DO NOT

use the changing table if it is damaged or broken.

z Set up this table to be level, stable, and structurally sound.
z This changing table may be used wit h or without a pad. The only pad approv ed for use with it

is the Contour Changing Pad available for purchase from pottery barn kids. This pad is
designed to be used in a space of at least 810mmx400mm (32inches x 16inches). If used,
place it within the rail-bounded c h anging area of the changing table.

z NEVER LEAVE THE CHILD UNATTENDED and always use the restraining system.

This changing table is intended for use with children weighing up to 50 pounds.

- To prevent death or serious injury from falls, always keep child within arm’s

PRE-ASSEMBLY

• Please all the instructions before beginnin g assembly. The illustration provided allow for
easier assembly when used in conjunction with the assembly instructions.

• For your safety, assembly by two adults is required.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-fee work

surface, as this will avoid dama ging any parts duri ng assembly. The shi pping box provides
and ideal work surface. Do not dispose of any cont ents until assembly is completed to
avoid accidentally discarding email parts or hardware.

• Use the parts and hardware lists to identify and separate each of the piece included.

• Note: do not fully tighten all bolts until all parts are i n pl ace. Failure to follow these

instructions may cause the bolts to misalign during ass em b ly.

• If using power tools to aid in assembly please use caution. Power tools can damage
hardware or split wood.

Page 1 of 3

TOOLS REQUIRED:
Phillips head screwdriver (not included)

HARDWARE:
A – Metal plate (x2)

B – Small Phillips head screws 8x19mm (x6)

ASSEMBLY:

1. Place the changing tabl e topper on dresser in upright position, as shown.

2. Using the Philips head screwdriver, attach the Meta l pl at es (A) to the back edge of the
changing table by inserting the S mall P h illips head screws (B).

3. Hardware should be checked periodically for tightness.

Page 2 of 3