pottery barn kids
THOMAS DRESSER HUTCH
PRE-ASSEMBLY:
Please read all instruction before beginning assembly. For your safety and ease,
assembly by two-person assembly is recommended. Save all packing materials until
assembly is complete to avoid accidentally discarding smaller parts or hardware. Use
caution when using power tools to aid in assembly. Power tools can split wood or strip
hardware if not used carefully.
PARTS INCLUDED:
Shelf (1)
TOOLS INCLUDED:
Phillips head screwdriver (not included)
HARDWARE:
A- Metal plate (x2)
B- Small Phillips head screws (x14)
C- Shelf support pegs (x4)
D- Brackets 48x21x10mm (2
E- Long screws 6x32mm (2)
F- Short screws 6x19mm (2)
G- Nylon strap 255x12x8mm (1)
1
ASSEMBLY:
Step#1 through #3
1. Set the dresser hutch on the short dresser.
2. Attach one of the (A) metal plates near the back edge of the dresser hutch by
inserting the (B) small Phillips head screws through the holes in the bracket. Allow
the screws to drill directly into the wood of the furniture. Repeat with other bracket.
3. Determine the desired height for shelf using the corresponding peg holes on the
hutch interior. Insert the (C) shelf support pegs into the pre-drilled holes until fully
secure. Place shelf onto the support pegs making sure the shelf is stable.
Thank you for your purchase.
stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
2
FURNITURE TIPPING RESTRAINT
Young children may be injured by tipping furniture. The use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection a gainst the unexpected tipping of furniture
due to small tremors, bumping or climbing. We recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
Hardware Included (also described on page one):
D - Brackets (x2)
E - Long screws (x 2)
F - Short screws (x 2)
G - Nylon strap (x 1)
INSTALLATION INSTRUCTIONS:
1. Locate a wall stud behind your furniture, Position a bracket (D) on the stud approximately 1” below
the top of the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit.
Attach a bracket (D) to the stud with the long screws (E) provided.
2. On the back of the furniture, a bracket (D) will need to be attached to the furniture frame at the top.
To do this, temporarily move the furniture into its final position and mark the loca tion of the wall
bracket on the furniture frame. Move the furniture away from the wall and place a bracket on the
mark. Mark and drill holes for screws with a 3/32” drill bit. Attach the bracket to the furniture with
the short screws (F) provided.
3. Move the furniture into its final position, taking care to line up the wall bracket with the furniture
bracket. Thread strap (G) through the bracket as shown in the illustration. T ighten strap until snug.
Do not over tighten.
3
Loading...