pottery barn kids
THOMAS TWIN/FULL BED
PRE-ASSEMBLY:
• For safety and ease, a ssemb ly by two adults is recommended.
• Remove all parts and hardwa re from the b ox and lay ou t on a clean , carpeted, or scratch- free work
surface. Use care as some parts or hardware may have sharp points or edges.
• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small
parts or hardware.
• Use the parts and hardware lists to identify and separate each of the pieces included.
• Read all instructions before beginning assembly. The illustrations provided allow for easier
assembly when used in conjunction with the assembly instructions.
• If using power tools to aid in assembly please use caution. Power tools can damage hardware or
split wood.
PARTS INCLUDED:
A - Headboard (1 pc)
B - Footboard (1 pc)
C - Side rail (2 pc)
D - Finials (4 pc)
E – Feet (4 pc)
F – Slat Roll (1 pc)
TOOLS NEEDED:
Phillips Head Screwdriver (not included)
HARDWARE INCLUDED:
G. Phillips Head Screws (28 pc) 8x30mm
Page 1/3
ASSEMBLY INSTRUCTIONS:
1. Attach the feet (E) to the bottom posts of the headboard and footboard as shown. Important: The
bottom of the bedpost has 4 holes, while the top of the bedpost has 3 holes.
2. Attach the side rails (C) to the headboard and footboard by inserting the hooked ends into the
corresponding slots.
NOTE: Side rails (C) are adjustable to two heights.
• If you are using a trundle, or are assembling the bed for to be used with a mattres s o n l y
(no box spring), please insert side rails into upper slots
• If you are using a mattress and box spring, please insert side rails into lower slots
.
3. Screw Finials (D) into the post of headboard and footboard.
.
.
Page 2/3
4. Lay slat roll in place onto the inner ledges of the siderails (C). Attach slats by inserting the Phillips
screws (J) through the pre-drilled end holes and tightening with Phillips screwdriver (not included).
5.Periodically tighten screws.
CARE INSTRUCTIONS:
• Dust often using a clean, soft, dry lint-free cloth.
• Blot spills immediately, and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered
finish.
• If the unit’s is to be stored, store in cool dry place and carefully package all original hardware to
protect from loss or damag e.
• Check fasteners periodically for tightness. DO NOT over tighten. This may cause dis t o r t i on or
breakage
Thank you for your purchase.
stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
Page 3/3
Loading...