Pottery Barn Teepee 2008 Assembly Instruction

pottery barn kids

TEEPEE

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly
when used in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all part and hardware from the box and lay out on a clean, carpeted, or scratch- free work

surface. Use care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidental ly discarding small parts
and hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause

the bolts misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split
wood.

PARTS INCLUDED:

A

Posts (10)

B

Plastic Connectors (5)

PARTS REQUIRED (packaged separately):

C

Teepee Fabric Cover (1)
Fabric Tie (1)

D

HARDWARE INCLUDED:

E

Bolt and Nut Set (10)

TOOLS REQUIRED:

F

Allen Key (included) (1)

Wrench (included) (1)

G

ASSEMBLY INSTRUCTIONS:

1. Connect (2) Posts (A) to one Plastic Connector (B), (Figure 1). Repeat until all (5) Teepee Poles are

assembled.

A

B

A

Page 1/3

2. Secure each Pole with (2) Bolt and Nut Sets (E) on the Plastic Connectors (B) (Figure 2).

E

E

B

G

A

3.

Align the poles and thread the Fabric Tie (D) through the predrilled holes, as shown.

A F

A

D

4. Tie the the thread in a loose knot, leaving approximately 5 inches of the Fabric Tie exposed between

the poles and the knot.

D

A

B

Page 2/3