Pottery Barn Speed Boat II Full Bed Assembly Instruction

pottery barn kids

SPEED BOAT FULL BED

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface.
(The shipping box provides an ideal work surface), this will avoid damaging any parts during assembly. Do
not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or
hardware.

• Two people recommended for ease of assembly.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting

assembly .

• The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause
the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split
wood.

PARTS INCLUDED:

A – Headboard (x1)
B – Footboard (x1)
C – Top tail (x1)
D – Siderail (x1)
E – Slat roll (x1)
F – Side panel (x1)

TOOLS REQUIRED:
Phillips head screwdriver (not included)

G – Ball tip Allen key (included)

1

HARDWARE INCLUDED:

H – Allen Bolt 1/4”x50x13mm(x8)

I – Allen Bolt 1/4”x28x13mm (x5)

J – Spring washer 1/4”x10x2mm (x13)

K – Flat washer 1/4”x16x2mm (x13)

L – Half moon washer 1/4”x24x8mm (x8)

M – Phillips head screw 8x30mm (x28)

N – Phillips head screw 7x20mm (x24)

O

– Mending plate 43x36x23mm (x4)

A

SSEMBLY:

1. Place the

Top Tail (C) on top of the footboard (B) as shown. Place a spring washer (J), then a flat washer (K)
over an Allen Bolt 1/4”x28x13mm (I). Fasten bolt and washers up into bottom of Tail Top through footboard
using Ball tip Allen Key (G) as shown. Repeat last 4 Allen bolts and washers.

2